Easily Light Pilot on Rheem Water Heater: Step-by-Step Guide
Are you in need of heating your hot water tank manually? The pilot light on your Rheem water heater might be out, and you may need to relight it. Lighting the pilot light on a Rheem water heater is a straightforward process that requires a few minutes of your time and a small screwdriver. This guide will walk you through the precise steps to light the pilot on your Rheem water heater.
But first, ensure that your Rheem water heater is suitable for this task. Most modern Rheem heaters come with electronic ignition systems, which don't require a manual pilot relighting. Always check your Rheem water heater's model and make sure it uses a standing pilot before proceeding.
Preparation for Lighting the Pilot
Before you start, gather a small screwdriver and a piece of newspaper or a towel to keep the area around your water heater clean and dry. Also, turn off the gas supply to your Rheem water heater for safety reasons. You'll find the gas cock usually located on the gas line near your water heater.
If you're unsure about any of these steps or are uncomfortable with handling gas lines, don't hesitate to contact a professional plumber. Gas leaks are dangerous and should only be handled by licensed professionals.
Turning Off the Gas
To turn off the gas supply, following these steps:
- Locate the gas cock, usually a handle or lever on the gas line near your Rheem water heater.
- Rotate the gas cock to the 'Off' position perpendicular to the gas line. The gas supply should be completely turned off.
Removing the Access Panel
Once you've turned off the gas, proceed to remove the access panel to expose the pilot light assembly:
- Turn the temperature control dial to the 'Off' position.
- Using the small screwdriver, unscrew the panel covering the pilot light area and remove it.
Lighting the Pilot
Now that you've accessed the pilot area, you can proceed to relight the pilot on your Rheem water heater:
Turning the Control Valve to 'Pilot'
First, rotate the control valve on your Rheem water heater to the 'Pilot' setting:
- You'll find the control valve on the bottom left corner of the water heater.
- Rotate the valve to the 'Pilot' position. This will align the gas line with the pilot light assembly.
Lighting the Pilot
With the control valve in the 'Pilot' position, you can now light the pilot:
- Press and hold the control knob firmly down.
- While holding the control knob, simultaneously press the igniter button. You should hear a clicking sound indicating that the button is functioning correctly.
- Continue holding the control knob for at least 30 seconds. This gives the smallest flame sufficient time to ignite and light the pilot.
- After 30 seconds have passed, slowly let off the control knob.
Check that the pilot light is burning steadily. If not, repeat the above steps. If the pilot light still doesn't stay lit, turn the gas cock back to the 'Off' position and contact a professional plumber.
Once the pilot light is burning steadily, turn the control valve back to the 'On' position and set your water heater's temperature to your desired setting. Replace the access panel and ensure it's firmly screwed back in place.
Congratulations! You've successfully relit the pilot on your Rheem water heater. Regularly check your water heater's pilot light to ensure it's always lit and burning steadily. If you encounter any issues or aren't confident performing these steps, always contact a licensed professional plumber for assistance.