Step-by-Step Guide: Reset Water Heater Pilot Light
If your water heater isn't producing hot water, the issue could be as simple as the pilot light having gone out. Luckily, relighting it is a straightforward process that you can handle safely and easily at home.
Before you get started, ensure you have the following at hand: a tankless water heater manual, a barbecue lighter or matches, and safety glasses. Once you have your tools ready, follow these steps to reset the pilot light on your water heater.
Understanding Your Water Heater's Pilot Light
Water heaters rely on a constantly burning pilot light to ignite the gas burner, which heats the water in the tank. The pilot light is located inside the PPAR (Pilot, Pressure, and Relief) valve, typically situated at the bottom of the water heater's front panel.
There are two types of pilot lights: standing pilots and intermittent ignition systems. Intermittent systems use spark ignition to light the gas, so they won't have a continuously burning pilot light. The instructions below are for standing pilots.
Locating the Pilot Light Knob and Gas Control Valve
First, locate the gas control valve on your water heater. It's usually positioned at the bottom of the unit, near the floor. The knob above it controls the pilot light. If the pilot light is out, the knob may be in the "Off" position.
Some water heaters may have a spark igniter instead of a pilot light. In this case, you won't see a constant flame, and you can skip to the section on relighting the burner using the spark igniter.
Preparing to Relight the Pilot Light
Before you begin, turn the gas control knob to the "Off" position. Allow the gas to dispersed from the system for at least five minutes. This safety measure helps prevent gas buildup, which can cause an explosion.
Next, turn the knob to the "Pilot" position. While holding down the knob, use your barbecue lighter or matches to light the pilot. Keep holding the knob for about one minute to ensure a steady flame. Once lit, release the knob and listen for the "whoosh" sound of the burner igniting. If the burner doesn't light, try relighting the pilot again.
Relighting the Burner Using a Spark Igniter
If your water heater has a spark igniter, there's no pilot light to relight. Instead, you'll need to reset the burner using the spark igniter. Start by locating the reset button, usually found near the control valve. This button might be called the "Hot Surface" or "Igniter" reset button.
Sometimes, the reset button may be covered by a metal plate screws to secure it. In this case, you'll need to remove the plate and the screws with pliers to access the reset button.
Resetting the Spark Igniter
With the plate removed, press and release the reset button. If the burner doesn't ignite, wait a few minutes and try again. If it still fails to light after five attempts, the burner may have a more significant issue, and you'll need to call a professional for repairs.
Once the burner is relit, replace the metal plate and screws. Remember to clean any soot from around the igniter opening to facilitate better ventilation and prevent future issues.
Checking for Leaks After Resetting the Pilot Light
After relighting the pilot light or resetting the spark igniter, check for any gas leaks. The smell of gas can indicate a leak. If you smell gas, turn off the gas supply valve immediately and ventilate the area.
It's also a good idea to inspect the area around the gas control valve for any signs of soot buildup. A sudden change in burner performance or an excess of soot can indicate a problem with the burner's operation or the thermocouple, which may need professional attention.
Congratulations! You've successfully reset the pilot light on your water heater. Regular maintenance checks can help prevent future issues and keep your water heater running smoothly. If you're ever uncertain about any aspect of your water heater's operation, don't hesitate to consult your user manual or contact a licensed professional for assistance.