how to restring dewalt weed eater

Dewalt Weed Eater Restring: Step-by-Step Guide

By Robert Anderson
AD

Is your DEWALT weed eater's line not spinning as it once did? No problem, restringing your weed eater can restore its cutting power. Let's guide you through the process of how to restring your DEWALT weed eater, step by step.

Restringing your weed eater isn't just about maintaining its performance; it's also about safety. A properly restrung weed eater ensures the line feeds out evenly, preventing potential breakage and reducing the risk of injuries. So, grab your new replacement line, and let's dive in.

Preparation: Gather Tools and Replaceable Parts

Before you start, gather the right tools. You'll need a flathead screwdriver, your new replacement line, and a pair of safety glasses. Also, ensure you're working in a well-lit, clear area to avoid any accidents.

AD
a close up of a person holding a hockey boot
a close up of a person holding a hockey boot
How to Change the String on a Dewalt 20v String Trimmer
How to Change the String on a Dewalt 20v String Trimmer
How to replace Dual String Trimmer line for DeWALT trimmers / Jon's DIY
How to replace Dual String Trimmer line for DeWALT trimmers / Jon's DIY

DEWALT includes a replacement line in the package, but if you've used that one before, purchase a new one that matches your weed eater's model and line type. Always use DEWALT approved lines for optimal performance.

Unwinding the Old Line

Begin by releasing the feeding spool. Use a flathead screwdriver to hold the spool in place while you unwind the old line. Wind it all the way out, pulling gently but firmly to avoid any tangles or snags.

HOW TO Re-String A Weedeater Grass Trimmer
HOW TO Re-String A Weedeater Grass Trimmer
Dewalt 20v String Trimmer Problems? Here’s How To Fix Them Fast
Dewalt 20v String Trimmer Problems? Here’s How To Fix Them Fast

If the old line resists, don't force it. Once removed, discard it, being careful not to contaminate the new line.

Threading the New Line

Start threading your new line from the middle of the spool. Pull about 3 feet of line out, then feed it through the eyelet in the feeding spool. Make sure it threads through the correct side to avoid any entanglements during use.

AD

Once through, pull the line beyond the spool, releasing some slack. This will prepare the lawn trimmer for reassembly and use.

Reassembling and Testing the Weed Eater

Before you put everything back together, ensure all parts are clean and debris-free. If necessary, use a soft brush to remove any grass clippings or dirt.

Next, reinsert the spool into the weed eater's head, following the manufacturer's instructions. Make sure the new line feeds through the correct guide, ensuring it doesn't get tangled or feed wrong during operation.

AD

Winding the Line

Now, wind the line back onto the spool. Start by holding the end of the line with your fingers, then press the button on your weed eater's head to wind. Keep winding until you have about 10 feet of line left.

CEASE winding when you have about 10 feet left, as too much line can cause feeding issues. Trim the excess line, and you're ready to go.

Testing the Restrung Weed Eater

Before you start trimming, safety first. Put on your safety glasses. Then, hold the weed eater vertically, activate it, and spin the feeding head. The line should feed out smoothly.

AD

Finally, horizontally check the line's feeding by holding the trimmer at a 45-degree angle and activating it again. If it feeds smoothly in both positions, you've successfully restrung your DEWALT weed eater!

Congratulations! You've just mastered the art of restringing your DEWALT weed eater. Always refer back to your owner's manual for any specific model instructions, and happy trimming!

AD