Restring Your Dewalt 20V Weed Eater: Step-by-Step Guide
If you're a proud owner of a DEWALT 20V trimmer, also known as the DW4012, you understand the importance of keeping it well-maintained. One crucial maintenance task is knowing how to restring a DEWALT 20V weed eater. Restringing your trimmer not only ensures optimal performance but also extends its lifespan. Here's a step-by-step guide to help you through the process.
Before we dive in, ensure you have the following tools and materials ready: the new spool of string (the one that came with your trimmer should work), a flathead screwdriver, and perhaps some gloves to protect your hands. Let's get started!
Preparing Your DEWALT 20V Trimmer
The first step is to prepare your DEWALT 20V trimmer for restringing. This involves disengaging the line release mechanism and stopping the spool from turning.
1. Disengage the Line Release Mechanism: There's a lock button near the keeper tab on top of the spool. Press this button to disengage the lock. Now, pull back the line release mechanism to release any tension on the line.
Removing the Old Line
Now that the line release mechanism is disengaged, you can remove the old line.
1. Pull Out the Old Line: Grasp the end of the old line and pull it.out gently but firmly. Continue pulling until the entire length of the line has been removed from the spool. You may need to use scissors to cut the line if it's tangled or knotted.
Preparing the New Spool of Line
Before you install the new line, ensure you're using the correct type of string for your DEWALT 20V trimmer. The DW4012 comes with a .080" (2.03mm) string, so make sure your replacement line is the same size.
1. Unwind the New Line: Unwind the new line from the spool, ensuring you have enough length to replace both sides of the trimmer. A good rule of thumb is to have about 20 feet (6 meters) of line for each side.
Installing the New Line
Now that everything is prepared, it's time to install the new line onto the spool of your DEWALT 20V trimmer.
1. Thread the Line Through the Spool: Place the loose end of the line through the hole on the center of the spool. Pull about 6-8 inches (15-20 cm) of line through.
Winding the Line onto the Spool
Winding the line correctly is crucial for optimal performance and safety. Here's how to do it:
1. Wind the Line in the Right Direction: Look at the top of the spool. You'll see arrows indicating the direction to wind the line. Always wind the line in this direction. Start winding from the outside of the spool and work your way towards the center. Ensure each layer of line overlaps the previous layer slightly to prevent it from unwinding.
Securing the End of the Line
Securing the end of the line is crucial to prevent it from unraveling during use.
1. Tuck the End of the Line: Once you've wound the required amount of line (you should have approximately 10-12 feet (3-3.6 meters) left on the spool), tuck the end of the line under one of the previous layers of line. This will secure it and prevent it from unwinding.
Reassembling and Testing Your DEWALT 20V Trimmer
Now that you've successfully restrung your DEWALT 20V trimmer, it's time to reassemble and test it.
1. Reattach the Line Release Mechanism: Gently pull the line release mechanism back into place. The line should now be able to unwind from the spool as you pull on it.
1. Test Your Trimmer: Hold the trimmer in a safe and controlled environment. Pull the trigger and let the line run out. If it works correctly, your DEWALT 20V trimmer is now ready for use!
Restringing your DEWALT 20V weed eater isn't as daunting as it may seem. With a little patience and the right tools, you can keep your trimmer in top shape and extend its lifespan. Happy trimming!