How to Replace Shear Pin on Ariens Snowblower
When faced with a non-functioning Ariens snowblower, it's frustrating. One common problem is a snapped shear pin. Don't worry, replacing it isn't rocket science. In this guide, we'll walk you through the process step by step, ensuring a smooth reset of your snowblower's functionality.
First, let's make sure you've got the right tools. You'll need a new shear pin (they're cheap and readily available), a wrench, and some Pentek All Weather Grease. Also, be sure to work in a well-lit, open area for safety and ease of use.
Preparation and Safety Measures
Before starting, ensure your snowblower is cool and hasn't been operated for at least 30 minutes to prevent any burns.
Next, Disconnect the spark plug wire to prevent the engine from starting accidentally. Safety first!
Accessing the Shear Pin Area
Locate the shear pin hole on the auger housing. It's typically found near the center of the machine, on the bottom-left side when viewing the snowblower from the front.
Using your wrench, loosen and remove the two nuts securing the covers over the shear pin hole. These nuts are usually located on the top and bottom of the auger housing.
Removing the Old Shear Pin
With the covers off, you'll see the shear pin extending through the auger shaft. Grab one end of the old pin with pliers or needlenose pliers and pull it out. If it's stuck, you might need to use a hammer and a piece of wood to gently tap it out.
Be careful not to damage the auger shaft while doing this. If the pin is severely damaged or the shaft is compromised, it might be wise to consult a professional before proceeding.
Installing the New Shear Pin
Before inserting the new pin, ensure it's the correct size for your Ariens model. The pin should fit snugly into the hole without excessive play.
Apply some Pentek All Weather Grease to the new pin before installation. This will help lubricate the pin and make future maintenance easier.
Inserting the New Pin
Insert one end of the new pin into the hole on one side of the auger housing. Push it in until it extends through the auger shaft and out the other side.
Make sure the pin is fully inserted. You should feel a bit of resistance as the pin meets the end of the hole on the other side.
Securing the New Pin
Once the pin is fully inserted, replace the two cover nuts you removed earlier. Tighten them using your wrench, but be careful not to overtighten.
Tighten to the same specification as the original nuts. If you're unsure, consult your Ariens snowblower's owner's manual for precise torque settings.
That's it! You've successfully replaced the shear pin on your Ariens snowblower. Reconnect the spark plug wire, and your snowblower should be ready for another winter's worth of clearing snow. Don't forget to check the shear pin periodically to ensure it's functioning correctly.