Step-by-Step: Replace Pull Cord on Husqvarna Chainsaw
Imagine being out in the woods, your Husqvarna chainsaw humming in your hands, when suddenly, the pull cord snaps, leaving you with a silent tool and a prolifically growing sigh. Don't let that happen to you. Knowing how to replace a pull cord on your Husqvarna chainsaw can save your day, your mood, and quite possibly, your entire woodcutting project. Let's dive into this essential guide to keep your chainsaw in top condition.
Before we start, remember that safety is paramount. Always wear appropriate safety gear, including gloves, protective clothing, and eye protection. Make sure to store your tools and equipment safely to avoid accidents. Now, let's tackle the task at hand.
Understanding Your Husqvarna Chainsaw's Pull Cord Mechanism
To replace the pull cord, you need to understand how it works. Your Husqvarna chainsaw's pull cord is connected to the starter wheel, which, when pulled, engages the flywheel, starting the engine. The cord runs through a housing, guides, and a spring-loaded tensioner, which keeps it taut and ready for use.
Knowing this, you can now anticipate the steps involved in replacing the pull cord. It's a straightforward process, but it requires patience and attention to detail.
Gather Your Tools
Before you start, ensure you have the following tools and equipment:
- New pull cord (matching the specifications of your machine)
- Screwdriver (Philips or flathead, depending on your model)
- Needle-nose pliers
- Flexible measuring tape or ruler
Disassemble the Pull Cord Housing
First, locate the pull cord housing at the bottom of your chainsaw. It's secured by a single screw. Using your screwdriver, remove this screw and carefully set it aside.
With the screw removed, gently pull out the housing. You may need to use a flathead screwdriver to pry it loose. Be careful not to damage the housing, as it's reusable.
Removing the Old Pull Cord
With the housing removed, you'll see the old pull cord, the starter wheel, and the spring-loaded tensioner. Before removing the old cord, mark its length with a permanent marker. This will help you match the length of the new cord.
Measure and Cut the New Pull Cord
Using your measuring tape or ruler, measure the length of the old cord, including the loop at the end. Add about 2-3 inches to this measurement for the new cord. This extra length accounts for the new cord's diameter being slightly smaller than the old one.
Cut the new cord to the measured length. Make a loop at one end using a glue-on plastic end, or tie a simple overhand knot if the cord doesn't have a preformed loop.
Thread the New Pull Cord
Begin threading the new cord from the top of the chainsaw, where the loop would normally be pulled from. Pass the cord through the hole in the housing, then around the starter wheel, and into the hole on the opposite side.
Next, pass the cord through the spring-loaded tensioner. You may need to use needle-nose pliers to help align the cord and the tensioner hole. Once the cord is through, pull it taut to ensure the tensioner is working correctly.
Reassemble the Pull Cord Housing
With the new cord threaded, you can now reassemble the housing. Reinsert it into the bottom of the chainsaw, ensuring the cord runs smoothly through it.
Replace the screw you removed earlier, securing the housing in place. Make sure the cord pulls smoothly without any binding or kinks. If it doesn't, you may need to adjust the tensioner or rethread the cord.
Test the New Pull Cord
With the new pull cord installed, turn your Husqvarna chainsaw over, so the guide bar is facing up. Pull the cord a few times to check its action. It should feel smooth and responsive. If it doesn't, double-check your work and ensure the cord is fully seated in the starter wheel.
Now that you've replaced your pull cord, your Husqvarna chainsaw is ready for another bout in the woods. Regularly maintain and check your pull cord to ensure it stays in good working order. Happy woodcutting!