Easy Weed Eater Pull Cord Replacement: Step-by-Step Guide
Experiencing a snap while trimming your lawn with a weed eater? It might be time to replace that pull cord. Don't let this daunting task deter you; with the right steps and a little patience, you can handle this mend like a pro. Let's delve into the nitty-gritty of replacing your weed eater's pull cord, ensuring your garden tool is back in action in no time.
Before we begin, ensure you have the following supplies: a replacement pull cord (ideally the same type and length as the original), a screwdriver, and a pair of pliers. Safety first – wear gloves to protect your hands and ensure young ones are at a safe distance.
Examining Your Weed Eater
Firstly, assess the damage. The pull cord typically breaks due to wear and tear or excessive tension. Inspect the remaining cord, the housing, and the reel to ensure no additional repairs are needed.
Next, familiarize yourself with your weed eater's make and model. Some models may have specific cord replacement procedures, so always consult your user manual if available. For this guide, we'll focus on the generalprocess that applies to most weed eaters.
Preparing the Weed Eater
Begin by disconnecting the spark plug wire to prevent accidental starting. If your model has a cover or housing over the reel, unscrew and remove it using your screwdriver. This will expose the cord reel and provide ample space to work.
With the housing removed, locate the clutch cover. This small dome-shaped cover protects the clutch from debris and cord wear. Using your screwdriver, carefully pry off the clutch cover, working your way around its edge until it pops off. Set it aside, keeping track of its position for later reassembly.
Removing the Broken Cord
Now, you'll remove the damaged cord. First, find and gently pull the remaining cord fragment, slowly unwinding it from the reel. Be cautious not to damage the reel or cause any tangling.
Once the old cord is completely removed, examine the reel and ensure no remnants of the old cord are left behind. Use your pliers to carefully straighten any bent or twisted parts of the reel, as they could hinder the proper functioning of the new cord.
Installing the New Pull Cord
Before installing the new cord, measure it against the original to ensure you have the right length. Cut the new cord to match the length of the old one, leaving a few extra inches for knotting.
With the new cord ready, it's time to thread it through the weed eater. Start by inserting the end of the cord through the hole in the reel's center, ensuring the new cord sandwiches the reel's rubber gasket. Pull the cord taut, allowing the gasket to rest snugly against the reel.
Winding the Cord
Now, begin winding the cord around the reel. Ensure you wind the cord in the same direction it was originally wound, typically clockwise. Maintain a consistent tension while winding to prevent any slippage or uneven tension.
As you near the end of the cord, leave about 6-8 inches of slack. This will become the new pull cord you'll use to start your weed eater. With the cord wound, reattach the clutch cover, ensuring it's properly secured and sits flush with the reel.
Reassembling the Weed Eater
Reattach the housing cover, securing it with screws. If your weed eater has a shoulder strap, reattach it as well. Finally, reconnect the spark plug wire, ensuring it's properly positioned and secure.
Your weed eater is now ready for a test run. Pull the new cord gently but firmly to start the engine. Adjust the tension on the new cord as needed, ensuring it's taut but not overly tight. With your weed eater back in working order, you're ready to tackle those overgrown weeds with confidence!
Regularly inspecting your weed eater's pull cord can help prevent unexpected snaps and downtime. Happy trimming!