How to Remove Agitator from Kenmore Washer 500 Series
If your Kenmore washer from the 500 series is giving you trouble, you might want to inspect or replace the agitator. The agitator is a critical component that cleans clothes by lifting and dropping them in the wash cycle. Here's a comprehensive guide on how to remove the agitator from your Kenmore washer 500 series.
Before you start, ensure you have the following tools: a Phillips screwdriver, a flathead screwdriver, a long-handled socket wrench, and some penetrating oil like WD-40. Also, prepare a towel and a basin to catch any water that may leak out.
Preparation and Draining the Washer
Safety is paramount when working with appliances. Start by unplugging the washer from the power source to prevent any accidental electrocution. You'll also need to drain the washer to avoid water spills and possible damage to your floor.
Locate the water supply hoses at the back of your washer. Use a flathead screwdriver to clamp the hose's valve, then disconnect the hoses. This will release the water in the washer. If there's still water left, you can run a drain cycle without starting the washer.
Accessing the Agitator
Now that the washer is drained, it's time to access the agitator. Place your basin underneath the agitator to catch any remaining water. Use a Phillips screwdriver to remove the four screws at the top of the washer lid, then lift it off. Next, grab a flathead screwdriver and remove the top panel's screws at the bottom. There should be about ten screws holding the panel down.
After removing the panel, you'll see the agitator shaft. Most models have a set screw that secures the agitator to the shaft. If your model does, use a flathead screwdriver to remove it. If your model doesn't, move on to the next section.
Removing the Agitator
If there's no set screw, your agitator is probably held in place by a retention ring. Use a long-handled socket wrench to turn the agitator clockwise. This should release the retention ring, allowing you to remove the agitator.
Even with a set screw, you might need to use a wrench to turn the agitator. Apply some penetrating oil around the agitator, let it soak for a few minutes, then use the wrench to turn it. If the agitator doesn't budge, check if there's a jam in the washer that's preventing it from turning.
Inspecting and Replacing the Agitator
Once you've successfully removed the agitator, inspect it for any damage. If you find any cracks or damage, it's best to replace the agitator rather than attempting to repair it. Keep in mind that the agitator's lifespan can be influenced by the type of clothes you wash and how often you run your washer.
If you decide to replace the agitator, ensure you buy one that's compatible with your Kenmore washer 500 series model. Kenmore 500 series washers come with either a one-piece or two-piece agitator, so it's crucial to get the right one.
Reinstalling the Agitator
Reinstalling the agitator is essentially the reverse of removing it. Start by applying penetrating oil to the agitator shaft and the inside of the agitator. Replacing the retinue ring or the set screw (depending on your model), then reinstall the top panel and the lid. Don't forget to reconnect the water hoses and plug the washer back in.
Before running a test cycle, make sure the agitator spins freely and that there are no leaks around the hoses.
And there you have it! You've now successfully removed the agitator from your Kenmore washer 500 series, inspected it, replaced it if necessary, and reinstalled it. Regular maintenance like this can extend the lifespan of your washer. If you're unsure about any step, don't hesitate to consult the user manual or contact a professional for assistance. Happy washing!