Step-by-Step: Change Oil on Ford Escape - DIY Guide
Changing the oil on your Ford Escape is a crucial part of maintaining your vehicle's engine health. Not only does it improve your car's performance, but it also extends its longevity. Here's a step-by-step guide to help you change the oil on your Ford Escape, tailored to models from 2013 onwards. Let's dive in!
Before we start, ensure you have all the necessary tools and materials. You'll need a drain pan, 5 quarts of synthetic or conventional oil (depending on your vehicle's requirements), a new oil filter, a socket wrench, a funnel, and some shop towels or rags. For your safety, make sure your Ford Escape is on a level surface and has cooled down for at least 30 minutes to prevent any burns.
Preparation
Begin by opening your Ford Escape's hood and locating the oil pan underneath the engine. It's a large, flat pan at the bottom of the engine. Position your drain pan underneath it to catch the used oil.
Next, find the oil filter located on the front passenger side of the engine. It's slightly above the oil pan and is connected to the engine by a bracket. Using your socket wrench, loosen the oil pan drain plug by turning it counterclockwise. Once you've loosened it, finish removing it by hand and allow the oil to drain completely into your drain pan. This may take a few minutes, so be patient.
Removing the Oil Filter
Now that the oil has finished draining, use your socket wrench to unscrew the oil filter from the engine. Again, turn it counterclockwise until it's loose enough to remove by hand. Place the oil filter in your drain pan to catch any remaining oil. Use a shop towel or rag to wipe the area clean and inspect the gasket on the oil filter. If it's in good condition, you can reuse it with the new oil filter. If not, replace it with a new one.
Before installing the new oil filter, coat the gasket with new motor oil. This creates a better seal and helps the oil flow freely. Screw on the new oil filter by hand, turning it clockwise until it's snug, then give it about ¼ to ½ a turn more. Don't overtighten it, as this can cause the gasket to break and lead to oil leaks.
Refilling the Oil
Once the oil filter is in place, replace the oil drain plug by hand, then tighten it using your socket wrench. Be careful not to overtighten it, as this can strip the threads. Wipe the area clean with a shop towel or rag to remove any spilled oil.
Now, locate the oil fill hole on top of the engine. It's usually near the back of the engine and has a capmarked "Engine Oil." Remove the cap and insert a funnel into the hole. Pour in the recommended amount of oil for your Ford Escape's engine. You can find this information in your vehicle's owner's manual or by searching online using your vehicle's make, model, and engine size.
Checking the Oil Level
After you've added the oil, give your Ford Escape's engine a few minutes to allow the oil to settle. Then, locate the oil dipstick, usually at the bottom front of the engine. Pull it out, wipe it clean with a shop towel or rag, and reinsert it all the way. Pull it out again and check the oil level. It should be within the "FULL" range on the dipstick. If it's not, add more oil, a little at a time, until it is.
Once you've confirmed the oil level is correct, replace the oil fill cap and run your engine for about a minute to allow the oil to circulate. Turn off the engine and wait a few more minutes for the oil to settle again. Recheck the oil level using the dipstick. If it's still within the "FULL" range, you're all set!
Disposing of the Used Oil and Filter
Do not pour the used oil down the drain or into the ground. It's crucial to dispose of it responsibly. Many auto part stores and service centers accept used oil and filters for recycling. Check with your local recycling center or auto part store for guidelines on how to dispose of it in your area.
After you've taken care of the used oil, take a moment to wipe down the area around the oil pan and oil filter to remove any spilled oil. This will help keep your Ford Escape's engine looking clean and well-maintained.
Congratulations! You've just changed the oil on your Ford Escape. Regular oil changes are essential for keeping your engine running smooth and prolonging your vehicle's life. Make sure to follow your vehicle's manufacturer recommendations for oil change intervals. Happy driving!