how to change oil in ford explorer

How to Change Oil in Ford Explorer: A Step-by-Step Guide

By Jessica King
AD

Changing the oil in your Ford Explorer isn't a task you should leave to the pros alone. With a bit of time and these step-by-step instructions, you can save money and keep your vehicle running smoothly. Remember, regular oil changes are vital for keeping your Explorer's engine lubricated and free from excess heat buildup. Here's a comprehensive guide to walk you through the process.

Before you start, make sure you have all necessary materials at hand. You'll need a wrench, an oil filter wrench, a new oil filter, the appropriate type and amount of oil (considering your Explorer's model year and engine type), an oil drain pan, a funnel, gloves, and protective clothing to keep yourself clean.

Preparation and Draining the Old Oil

The first step is to prepare your Explorer for the oil change. If possible, start the engine and let it run for about 15 minutes. This warms up the oil, making it easier to drain. After warming, turn off the engine and allow the oil to settle for a few minutes.

AD
Oil Change
Oil Change
2006 Ford Explorer Oil Change Required Light Reset
2006 Ford Explorer Oil Change Required Light Reset
Ford Explorer Service Manual
Ford Explorer Service Manual

Locate the engine oil pan under your Explorer. Position your drain pan underneath and use your wrench to loosen and remove the plug. Allow the old oil to drain completely into the pan. This may take a few minutes, so be patient.

Removing the Old Oil Filter

Once the oil has finished draining, use your oil filter wrench to loosen and remove the old oil filter. If the filter is too tight, you may need to use both hands or apply more force with the wrench. Make sure to wrap a cloth or rag around the filter to catch any spilled oil.

The 5 Best Engine Oils For Ford Explorer
The 5 Best Engine Oils For Ford Explorer
the engine compartment of a car with its hood open and an air filter on it
the engine compartment of a car with its hood open and an air filter on it

Before installing the new oil filter, tip it sideways and oil the rubber gasket using the new oil you'll be pouring into the engine. This helps create a clean seal and makes removing the filter easier during future oil changes.

Installing the New Oil Filter and Oil

Screw on the new oil filter by hand until it's snug, then give it about one more turn. Be careful not to overtighten, as this can cause the filter to leak or become difficult to remove later. Reinstall the oil pan plug using your wrench and tighten it snugly (but not overly tight).

AD

Using a funnel, begin pouring the recommended amount of oil into the engine. Check your Ford Explorer's owner's manual for the exact amount. Allow the oil to settle into the pan, then check the oil level using the dipstick. Add more oil if necessary, until the level is within the "FULL" range on the dipstick.

Resetting the Oil Life Monitor and Final Checks

After adding the new oil, locate your Explorer's onboard computer and reset the oil life monitor. Typically, this involves pressing the "TRIP" or similar button to cycle through the options until you see "OIL LIFE". Press and hold the button until the system resets the indicator to 100%.

Start the engine and let it run for a minute, allowing the new oil to circulate throughout the engine. Check for any leaks around the oil pan plug and oil filter. If there are no leaks, turn off the engine and allow the oil to settle for a few more minutes. Recheck the oil level using the dipstick and add more oil if needed.

AD

Congratulations, you've successfully changed the oil in your Ford Explorer! Regular oil changes are essential for keeping your vehicle in top shape. Make sure to check your owner's manual for recommended oil change intervals and monitor your oil life monitor frequently. Happy driving!

AD