Change Oil Ford Escape: Step-by-Step Guide
Changing your Ford Escape's oil isn't as daunting as it might seem. With the right tools and a little bit of know-how, you can save time and money by doing it yourself. This guide will walk you through the process step-by-step.
Before you start, make sure you have the right motor oil and filter for your Ford Escape. Consult your owner's manual for the recommended oil type and weight, as well as the correct size for the oil filter. You'll also need a wrench, an oil filter wrench, a funnel, an oil drain pan, and possibly an oil warmer for colder temperatures.
Preparation
Make sure your Ford Escape is on a flat surface and the engine is cool to avoid any burns. It's a good idea to change the oil after the engine has been off for at least 30 minutes.
Place your drain pan under the oil pan, which is located at the bottom of the engine. You might need to remove the plastic splash guard to access it.
Draining the Old Oil
Using your wrench, loosen the oil pan drain plug by turning it counterclockwise. Be careful not to ove,tighten or you could strip the threads.
Once it's loose enough, remove the drain plug by hand and allow the old oil to drain completely. This might take a few minutes, so be patient.
Removing the Oil Filter
Position your oil drain pan underneath the oil filter. Using your oil filter wrench, loosen the filter by turning it counterclockwise. You might need to use some force, but be careful not to damage the filter.
Once the filter is loose, remove it by hand and set it aside. Make sure to save the gasket for recycling.
Replacing the Oil Filter and Drain Plug
Before installing the new oil filter, spread a small amount of new motor oil around the gasket. This helps create a better seal and makes it easier to remove the filter during future oil changes.
Screw on the new oil filter by hand, turning it clockwise until it's snug. Then, give it about ¾ of a turn. Tightening it too much can damage the gasket and cause a leak.
Reinstalling the Drain Plug
Clean the area around the oil pan drain hole to ensure no old oil or debris gets inside. Reinstall the drain plug by hand, then tighten it with your wrench. Be careful not to overtighten.
Once the plug is tightened, use a torque wrench to ensure it's at the correct torque specification. You can find this information in your owner's manual.
Adding New Oil
Use a funnel to pour the correct amount of new motor oil into the oil fill hole, which is located on top of the engine. It's usually marked with an oil can symbol.
Allow the oil to settle for a few minutes, then check the oil level using the dipstick. Add more oil if necessary, but be careful not to overfill.
Resetting the Maintenance Required Light
After you've added the correct amount of oil, you'll need to reset the maintenance required light on your Ford Escape's dashboard.
To do this, turn the ignition to the on position, but don't start the engine. Press and hold the trip reset button for about 10 seconds, then release it. The light should turn off, indicating that the oil has been changed.
Checking for Leaks
After starting your engine, allow it to run for a minute, then shut it off. Check underneath the vehicle for any leaks around the oil pan or filter.
If everything looks good, let the engine sit for a few more minutes to allow the oil to settle, then recheck the oil level and add more if necessary.
That's it! You've successfully changed the oil in your Ford Escape. Regular oil changes are crucial for maintaining your vehicle's engine health, so make sure to set a reminder to change your oil every 5,000 to 7,500 miles or every 6 to 12 months, depending on your driving conditions. Happy driving!