Step-by-Step: How to Backwash Hayward Sand Filter
Looking to maintain your pool's sparkling clarity? Understanding how to backwash your Hayward sand filter is a crucial part of pool maintenance. This process helps to clean out contaminants and keep your filtration system functioning at peak performance. In this guide, we'll walk you through the steps to properly backwash your Hayward sand filter.
First, it's essential to understand when and why you should backwash your filter. Typically, you should backwash your filter when the pressure gauge shows an increase of about 8-10 psi from its clean pressure. This usually means it's time to clean the filter and improve its efficiency.
Preparing to Backwash Your Filter
Before you start, ensure that your pool pump is turned off. Safety first! Once your pump is off, locate the multiport valve on your filter. This valve allows you to switch between different filter functions. With the valve set to 'Filter', proceed to the next step.
Next, you want to determine the direction of the plumbing. This is crucial for ensuring that the water flows correctly during the backwashing process. The simplest way to do this is to remove the pump's lowest union nut and observe which way the water comes out. Mark this direction for future reference.
Starting the Backwashing Process
Now that you've prepared your filter, it's time to start the backwashing process. Turn the multiport valve to the 'Backwash' setting. This setting reverses the direction of the water flow, cleaning out any dirt and debris trapped in the sand.
Once the valve is set, turn on your pool pump. You should notice the water running through the system in the opposite direction. Allow the water to run for about 2-3 minutes before continuing. After this time, turn the pump off and the valve back to the 'Filter' position. This step helps to settle the sand back to the bottom of the filter.
Rinsing the Filter
After the sand has settled, turn the valve to the 'Rinse' setting. This step helps to clean any remaining dirt from the system. Turn the pump back on and allow the water to run for about 30 seconds to a minute. After rinsing, turn the pump off and the valve back to the 'Filter' setting.
Finally, turn your pump back on. The pressure on the gauge should now be back to its normal level, indicating that the filter has been successfully backwashed. If the pressure remains high, you may need to replace the sand in your filter.
Maintaining Your Hayward Sand Filter
To keep your Hayward sand filter functioning optimally, it's important to maintain it regularly. This includes replacing the sand every 3-5 years, depending on your pool's usage. Also, inspect your filter's lateral assembly and manifold for any signs of damage or wear.
In addition to regular maintenance, ensure that you're using the right sand for your filter. Hayward recommends using their #20 silica sand for their filters. Using the wrong type of sand can negatively impact the filter's efficiency.
Replacing the Sand in Your Filter
When it's time to replace the sand in your filter, the process is quite similar to backwashing. First, turn off your pool pump and open the air bleed valve on the filter. This helps to release any pressure built up inside the tank.
Next, remove the drain plug at the bottom of the tank to allow the old sand to drain out. Once the old sand is completely drained, replace the drain plug and refill the tank with new sand. Finally, backwash the system according to the steps outlined above.
Regularly backwashing your Hayward sand filter is key to keeping your pool water clean and clear. By following these steps and maintaining your filter regularly, you can extend the life of your filter and enjoy pristine pool water all season long.