Step-by-Step: How to Backwash Your Hayward Pool Filter
Backwashing your Hayward pool filter is a crucial maintenance task that helps keep your pool water clean and clear. While it may sound like a daunting task, with the right steps and a little practice, you'll be a pro in no time. Here's a step-by-step guide to help you master the art of backwashing your Hayward pool filter.
First things first, it's important to understand why backwashing is necessary. Over time, your filter collects dirt, debris, and other contaminants that can clog the system and reduce its efficiency. Backwashing reverses the flow of water through the filter, helping to dislodge and remove these particles, thereby restoring your filter's functionality. Now, let's dive into the process.
Preparing for Backwashing
Before you begin, make sure to gather the necessary equipment. You'll need your pool's filter handle, a filter tank (if it's a sand or DE filter), and a shovel (if you have a sand filter).
There's no set rule for how often you should backwash your filter, but a good general guideline is to do it once a week or after every 8-24 hours of filter runtime, depending on how heavily you use your pool.
Know Your Filter Type
Before you start, it's crucial to know what type of filter you have. Hayward makes three types of filters: cartridge, sand, and DE (diatomaceous earth). The process for each filter type is slightly different, so make sure you're following the right steps for your specific filter.
Line Up the Valves
Locate the multi-port valve on your filter, usually at the frontend or side. It's the black disk with various settings: Filter, Backwash, Rinse, Waste, and Winter. For backwashing, you'll need to line it up with the 'Backwash' setting.
Next, close all the valves in your system, including those at the skimmer, pump, and multiport valve itself. This prevents water from flowing out during the backwashing process.
Backwashing Your Filter
Now that you've prepared, it's time to start the backwashing process. Remember, the goal is to push water backwards through the filter, so the water will flow from the multiport valve outlet.
If you have an DE filter, you'll need to remove the skimmer baskets and any ladders or diving boards. This allows water to flow freely and ensures all DE is removed.
Sand and DE Filters
For sand filters, you'll need to remove the STD-40 or SVR-40 header assembly, lift off the canister lid, and remove the lateral assembly. This gives you access to the sand and DE inside. For DE filters, you'll also need to remove the filter grid.
Before starting, disconnect the plumbing lines from the multiport valve. Next, turn the handle on the multiport valve to the 'Backwash' setting. Connect the waste hose from the filter to a nearby drain point, ensuring it's functioning correctly.
Cartridge Filters
Backwashing a cartridge filter involves opening the filter tank and removing the cartridge. First, turn off the pump and wait for the filter pressure to drop significantly to avoid any water spillage. Next, open the tank and remove the cartridge, being careful not to damage it.
Once the cartridge is out, use a hose to spray off the dirt and debris. It's best to do this outside to avoid making a mess. After cleaning, let the cartridge dry out for at least four hours before reinserting it into the tank.
Final Touches
After backwashing, it's important to reset your multiport valve to rebind the laterals and coat the sand for sand filters. For DE filters, you'll need to add more DE. Cartridge filters, on the other hand, just need their cartridges reinserted.
Once everything is back in place, turn your pump back on and line up the multiport valve with the 'Filter' setting. Finally, open the valves at the skimmer and pump. The system should now start filtering again.
That's it! You've just successfully backwashed your Hayward pool filter. Regular backwashing will keep your pool water sparkling clean and maintain your filter's longevity. Happy swimming!