How to Replace an Andersen Storm Door Screen
If you're a homeowner with an Andersen storm door, you know that over time, the screen can become damaged, weathered, or simply worn out. Replacement might seem like a daunting task, but it's actually a straightforward process that can be accomplished with the right tools and a bit of know-how. Follow this comprehensive guide to replace your Andersen storm door screen.
Before we dive into the steps, ensure you have the following tools and materials: a new screen, a flathead screwdriver, a pair of pliers, aPhilips screwdriver (if yourdoor uses screws instead of pins), and some protective gloves for handling the screen's edge.
Preparation: Removing the Old Screen
The first step is to carefully remove the old screen. Begin by opening your storm door and locating the pins or screws that hold the screen in place. These are typically along the top and bottom edges.
Using your flathead or Philips screwdriver, remove these pins or screws, storing them safely as you'll need them for the new screen. Once the fasteners are out, gently lift the old screen out of the door's frame.
Inspect the Frame
Before installing the new screen, take a moment to inspect the door's frame. Look for any signs of rust, damage, or wear that could compromise the new screen's fit or lifespan. If you find any issues, address them before proceeding.
Also, make sure the door's frame is clean and free of debris. This will ensure a snug fit for the new screen and make the installation process smoother.
Measure the Storm Door Frame
Before purchasing a new screen, it's crucial to measure the storm door frame accurately. Measure both the width and height from the inside of the frame, as this is where the screen will fit.
While Andersen storm doors come in standard sizes, it's always a good idea to double-check your measurements to ensure a perfect fit. Many hardware stores offer custom-screen making services, so if you can't find the perfect size off the shelf, don't hesitate to order one.
Installing the New Screen
Now that you've prepared the frame and obtained the correct size screen, it's time to install the new screen. Start by inserting the new screen into the frame, ensuring it fits snugly without any gaps. The screen should fit perfectly within the frame, with no excess material at the edges.
The screen should also rest evenly on the frame's bottom edge, with no sagging in the middle. If the screen isn't fitting as expected, adjust it carefully to ensure a proper fit. If necessary, trim the screen lightly with scissors, taking care not to cut it too short.
Secure the Screen
Once the screen is perfectly fitted, it's time to secure it in place. If your door uses pins, align the new screen with the pin holes. Insert the pins from the inside of the frame, using a hammer if necessary. Push the pins in until they are secure, but take care not to bend or break them.
If your door uses screws, follow the same process, but use a screwdriver to tighten the screws instead of a hammer. Ensure the screws are tight enough to hold the screen securely, but not so tight that they warp or damage the screen.
Test the New Screen
After securing the screen, give it a gentle tug to ensure it's held firmly in place. Try opening and closing the storm door to ensure the screen moves smoothly and doesn't interfere with the door's operation.
Check for any areas where the screen might be too tight or too loose, and adjust as needed. Regularly opening and closing the door over the next few days will help ensure the screen is properly secured and won't come loose over time.
Congratulations, you've successfully replaced your Andersen storm door screen! With a little care and maintenance, your new screen should provide you with years of reliable service. Regularly inspect your screen for any signs of wear or damage, and address any issues promptly to keep your storm door in top working order.