How to Attach String to Dewalt String Trimmer
String trimmers, like the Dewalt string trimmer, are essential tools for maintaining well-groomed lawns and landscapes. However, replacing the string, or line, can be a hassle if you're not sure how to do it. This step-by-step guide will walk you through the process of putting new string on your Dewalt weed eater, making it easy and efficient.
Before we dive in, ensure you have the right type of string for your Dewalt weed eater. Consult your user manual or check Dewalt's website for the recommended string type and size. Typically, Dewalt trimmers use either .080 or .095-inch twisted or round lines.
Preparation
Prepare your Dewalt weed eater for string replacement by following these initial steps:
1. **Turn off and unplug** your weed eater to ensure safety during the process. Allow the cutter head to stop completely before proceeding.
Empty the String spool
Remove any remaining line from the spool to make room for the new string:
- Hold the cutter head's cover in place.
- Pull the old line out of the head, continuing until the entire line is removed, and the spool is empty.
Ready the new string
Before loading the new string, make sure it's the correct size and type for your Dewalt weed eater. Also, trim the new string to the appropriate length:
- Measure out about 10 to 15 feet of new line, depending on your model and personal preference. Longer lengths can provide extra use time but may also increase the risk of breakage.
- Cut the measured line in half, creating two equal-length sections.
Loading the new string
With your Dewalt weed eater prepared and the new string ready, follow these steps to load the line:
1. **Insert the line** through the eyelet on one side of the cutter head and pull it until both ends are even, with about 3 to 4 feet of line extending from both sides.
Wind the string onto the spool
Begin winding the new line onto the spool, following the manufacturer's recommended direction (usually clockwise when looking at the cutter head from above):
- Hold the line taut with one hand and use your other hand to wind the string onto the spool, keeping it as tight and even as possible.
- Ensure you maintain equal lengths of line on each side as you wind, stopping once you've reached the end of the measured line (about 3 to 4 feet remaining).
Securing the string
Once you've successfully wound the new string onto the spool, secure it in place to prevent unwinding:
- Insert one of the feeding spool cap's holding pins, or locking screws, through the appropriate hole in the spool's hub. Make sure it locks into place, securing the newly wound string.
- Reassemble the cutter head, and you're ready to go!
Testing your work
Before tackling your next yard work project, test your Dewalt weed eater's new line to ensure it feeds correctly:
1. **Plug in and turn on** your weed eater.
2. **Hold down the线gressor** (feed spool release) until the trimmer head begins to rotate.
3. **Release the feed spool** once the head is spinning. The new line should feed out automatically as you trim, indicating that you've successfully replace the string on your Dewalt weed eater.
Congratulations! You've just learned how to put string on your Dewalt weed eater, ensuring optimal performance and extended tool lifespan. Regularly replacing the line will keep your lawn looking its best, while proper maintenance will keep your weed eater running smoothly for years to come. Happy trimming!