"Link ALTEC Lansing Speakers: A Step-by-Step Guide"
Guest speakers, supplemented by Altec Lansing audio systems, enhance your event's success. Despite Altec's robust wiring diagrams, linking speakers brings unique challenges. Below, we explore the process, focusing on Altec Lansing SRS60. Let's dive in.
Although Altec Lansing speakers are revered for their durability, correctly wiring them is crucial. Failure can lead to damaged equipment and poor audio performance. Before we start, ensure you have the correct cables, typically banana plugs or spring clips, and a multimeter for troubleshooting.
Understanding Altec Lansing Connectivity
Altec Lansing speakers follow a standard connectivity layout. The main speaker, known as the 'master,' has two sets of terminals: input (from your source device) and output (to other speakers).
Configuration differs among models. For the SRS60, Channel 1 (L+R) is the input, and Channel 2 is the output to other speakers. Ensure you use the right pair of cables for each terminal.
Speaker Impedance and Power Handling
Each speaker has an impedance and power rating. Misinterpretation might lead to overheating or damaging your speakers. The SRS60 has an 8Ω impedance and can handle 150 watts of power. Matching these figures is critical while connecting additional speakers.
Most Altec Lansing models are 8Ω; using non-matching impedances can cause issues. Ensure that all connected speakers have identical impedances to avoid electrical imbalances and potential damage.
Resistance Check Using a Multimeter
Before wiring, check each speaker's resistance. Connect your multimeter to the terminals. For a functional 8Ω speaker, your multimeter should display 7.799 - 8.201 ohms. If it shows an open or short circuit, the speaker needs repair.
Test each speaker, replacing any faulty units before proceeding. Performance enhancements rely on fully functional speakers.
Wiring the Speakers
Once verified, wire the speakers starting with the main (master) unit. Below, we use the SRS60 as an example but modify based on your model.
If the master unit was correctly wired, connect your source device (e.g., TV, receiver) to the input terminals - for SRS60, this is Channel 1. The wires from your source device's output should connect to Channel 1's L+R terminals. Then, link the output terminals (Channel 2) of the master to the input (Channel 1) of the other speakers.
Creating Speaker Clusters
Cluster speakers, typically three or more, for wider audio dispersion. Your master should be in the center, surrounded by identically impedance speakers. Wire the nearest restaurant-style: L+R output of the master goes to the first satellite's L+R input, then the second satellite's L+R input, and so on.
Test each speaker cluster by playing audio. Issues might occur if the wiring is reversed, causing damage. If problems persist, re-check resistance and re-wire if necessary.
Final Maintenance Checks
Once all speakers work, perform final checks. Ensure no wires are loose, and each speaker receives power without loud popping noises. Regularly clean dust from the speaker's vents to maintain acoustic performance.
As your audio enhances your guests' experience, your Altec Lansing setup, now perfectly wired, ensures memorable events. Impress your audience with clear, audible presentations. Happy hosting!