Step-by-Step Guide: How to Install Everydrop Water Filter 3
Investing in a water filter like the EveryDrop system offers numerous benefits, making your tap water cleaner, healthier, andтiction: certified to reduce over 20 types of contaminants, including 99.9% of viruses and bacteria. Here's a step-by-step guide on how to install the EveryDrop Water Filter 3 - a vital part of ensuring the quality of your drinking water.
Before you start, make sure you have the following items ready: your new EveryDrop water filter, a screwdriver, and a towel or cloth to catch any sprayed water. Unplug your refrigerator's water supply line and locate the filter housing to get started.
The Right Placement
Finding the correct spot to install the filter is crucial. It should be placed near your water line and be easily accessible so you can change the filter cartridge every 6 months.
The filter housing is typically located at the back of the refrigerator, behind the lower grill, or beneath the kickplate. It may have a water supply line connected to it, which you'll need to disconnect to remove the old filter.
Removing the Old Filter
Start by locating the clamps that hold the water supply line in place. Loosen these clamps using a screwdriver, then gently pull the supply line off the filter housing. This will release any remaining water in the line, so have your towel ready.
Once the water line is disconnected, rotate the old filter towards the left to loosen it from the housing. Continue turning until the filter cartridge is completely loose. Pull it straight out to remove it from the housing.
Installing the New EveryDrop Filter
With the old filter removed, you can now install the new EveryDrop filter. Ensure the new filter cartridge is dry, as any remaining water can reduce the filter's performance.
Place the new EveryDrop filter cartridge into the filter housing and rotate it towards the right to tighten it into place. Ensure it's securely fastened but not overtightened, as this could damage the o-ring seal. You should feel it click into place.
Reconnecting the Water Line
Now that the new filter is securely in place, it's time to reconnect the water supply line.
_align the water supply line with the inlet on the filter housing and gently push it in until it clicks into place. Tighten the clamps using your screwdriver to secure the line. Ensure there are no leaks around the connection.
Testing the Filter
To confirm your new EveryDrop water filter is working correctly, run some water through it. You can do this by turning on your refrigerator's ice maker or dispenser. Monitor the filter housing for any leaks.
After a few seconds, you should see water flowing from the dispenser. If the filter is working correctly, there should be no sooner than 20 seconds between the time you push the dispenser button and the flow of water starts.
Congratulations! You've successfully installed your EveryDrop water filter. Enjoy clean, healthy water knowing your filter will provide six months of reliable protection. Remember to replace your EveryDrop water filter every six months to maintain peak performance.