How to Change Sand in Hayward S200 Pool Filter
The Hayward S200 is a dependable sand filter that ensures your pool water remains clean and sparkling. Like all filtration systems, it's essential to change the sand periodically to maintain its efficiency. Here's a comprehensive guide on how to change sand in your Hayward S200 pool filter.
Before we dive into the process, ensure your pool is closed for the season or the filter has been turned off and the pressure has equalized. Safety first, right? Now, let's get started.
Preparation for Sand Change
Changing the sand in your Hayward S200 filter is a straightforward process that requires minimal tools. Here's what you'll need:
- Replacement sand (ensure it's #20 silica sand)
- Garden hose
- Teflon tape (for threading)
- Rust penetrant (optional, for stuck bolts)
- Work gloves
Now, let's discuss the sand replacement process in detail.
Draining the Filter
The first step is to drain the filter tank. Here's how:
- Open the waste plug at the bottom of the filter, allowing the sand and water to drain.
- Once drained, close the waste plug.
Remember, the tank will hold about 50 lbs of sand. Drain it completely before proceeding.
Removing the Internal Filter Parts
Before you can remove the sand, you'll need to take out the internal parts. Here's how:
- Remove the topAssembly. This involves unscrewing the clamp bands that secure the MultiPort valve.
- Lift off the lid to expose the filter contents. Be careful; it's heavy.
- Remove the lateral assembly by unsnapping it from the tank.
With the internal parts removed, you're ready to remove the old sand.
Removing the Old Sand
Before you start, lay down a tarp or some old sheets to catch the sand. Here's how to remove it:
- Remove the diffuser at the bottom of the tank. You may need to use a wrench to loosen it.
- Turn the tank upside down, and allow the sand to pour out. You can use a shovel to speed up the process.
The old sand should be discarded, as there's no reusing it. Now, let's add the new sand.
Adding the New Sand
Replacing the sand is a simple matter of adding new #20 silica sand back into the tank. Here's how:
- Ensure the tank is right-side up again.
- Using a shovel, gently pour the new sand back into the tank until you've added about 45-50 lbs.
You want the sand level to be 1/3 up the inside wall when the laterals are installed. This ensures optimal filtration.
Reassembling the Filter
With the new sand added, it's time to reassemble the filter. Here's how:
- Install the laterals, ensuring they're properly seated in the diffuser.
- Replace the diffuser, re-tightening it as you did when removing it.
- Reinstall the top assembly, securing it with the clamp bands.
Now, it's time to prime the filter and get your pool water flowing again.
Priming the Filter
Priming the filter replaces the air in the pump with water, allowing the filter system to function properly. Here's how:
- Turn the waste lever to the 'waste' position.
- Remove the air bleed screw at the top of the filter.
- Connect your garden hose to the winterizing plug at the bottom of the pump.
- Turn the hose on full blast, aiming the water at the air bleed screw.
- When water starts coming out of the top air bleed, turn off the hose.
- Replace the air bleed screw.
- Turn on the pump, switching the waste lever back to 'filter'.
Your Hayward S200 filter should now be fully operational with its new sand. Enjoy your clean pool water!
Regularly changing the sand in your Hayward S200 is a key part of pool maintenance. It helps maintain water quality and extends the life of your filter. But remember, every pool and every system is unique. Always consult your pool's specific manual and maintain it according to its guidelines.