How to Calibrate Samsung Top Load Washer
Is your Samsung top load washer not cleaning your clothes as well as it used to? It could be time for a recalibration. This straightforward process helps your washer maintain performance and longevity. Let's walk you through how to calibrate your Samsung top load washer, ensuring your laundry is always fresh and clean.
Before we dive into the steps, remember that calibration does not fix hardware issues. If your washer is making unusual noises, leaking, or not spinning, it's best to call a professional for repair. Now, let's get started with the calibration process.
Preparing Your Washer for Calibration
Before you begin, ensure your washer is empty and the power is disconnected. This safety measure prevents any accidents during the process.
To disconnect the power, locate the power cord behind your washer. Pull it out from the outlet, or switch off the power breaker if your home's electrical system uses one.
Accessing the Control Panel
The control panel on Samsung top load washers is where the calibration process begins. Locate the control panel on the top of your washer. You'll need a flat-bladed tool like a credit card or a thin spatula to access the control panel screws.
Carefully insert the tool into the small hole on the top right of the control panel. Press gently to release the clips securing the panel. Once released, lift the panel up to expose the control panel screws. Using a Phillips-head screwdriver, unscrew and remove the screws.
Calibrating the Rinse Aid and Detergent Dispensers
With the control panel removed, you can now access and calibrate the rinse aid and detergent dispensers. If your washer has a softener dispenser, you can calibrate that as well, following the same steps.
Start by pressing and holding the corresponding button (Rinse Aid, Detergent, or Softener) for 5 seconds. lembmer that you're holding the button, open the dispenser drawer and release the button. Wait for the dispenser to dispense water, then close the drawer.
Repeat this process three times for each dispenser. This step ensures that the dispensers are primed with water, allowing them to function accurately during the wash cycle.
Calibrating the Washer's Water Level
Next, we'll calibrate the water level to help your washer use the right amount of water for each load. This process involves filling and draining the washer's tub, ensuring the water level is correct.
First, fill your washer's tub with water using the 'Bulky' cycle and the hottest water temperature. Allow the tub to fill completely, then stop the cycle once it reaches the desired water level. Drain the water completely from the tub.
Checking the Water Level
Now that the tub is empty, let's check the water level. Using a ruler or a measuring tape, carefully measure the water level when half a cycle of water has been added. Compare this measurement with your washer's manual, which indicates the ideal water level for different load sizes.
If the water level is incorrect, adjust the water level float (located inside the washer's tub) according to your washer's manual. Check the water level again after adjusting the float to ensure it's now accurate.
Testing the Calibration
With both the dispensers and water level calibrated, it's time to test the calibration by running a test cycle. Fill the tub with water using the 'Normal' cycle and normal water temperature. Allow the cycle to run completely.
After the cycle is finished, check if the water level and detergent distribution are accurate. If so, your Samsung top load washer has been successfully calibrated. If not, repeat the calibration process until the test cycle runs perfectly.
Now that your Samsung top load washer is calibrated, it's ready to handle your laundry needs with renewed efficiency. Regular calibration ensures your washer maintains optimal performance, saving you time, water, and energy in the long run. Happy washing!