How to Thread Viking Husqvarna Sewing Machine
Ever wanted to explore the art of Viking embroidery with your Husqvarna Viking sewing machine? Threading your machine with the right materials is the first step in transforming your fabric into a Norse-inspired masterpiece. Let's dive into a step-by-step guide on how to thread your Husqvarna Viking sewing machine for Viking embroidery.
Before we start, ensure you have the following materials: your Husqvarna Viking sewing machine, embroidery threads (preferably metallic or stranded coton à broder for Viking motifs), a spool cap, and a seam ripper or a spool pin to secure your thread.
The Top Loading System
Husqvarna Viking machines feature a top loading system, making threading an effortless task. Start by turning your machine's hand wheel to bring the take-up lever to its highest position, ensuring your thread path remains unobstructed.
Now let's move on to threading the machine using your chosen embroidery thread.
Preparing the Thread
Begin by winding your embroidery thread onto the spool cap. This step might seem unnecessary, but it helps prevent tangles and ensures smooth feeding into your machine. Wind the thread clockwise, keeping it taut and close to the spool.
Once you've wound the thread, secure the spool cap onto your machine's thread stand. Position it so that the thread flows from the spool cap, over the thread stand, and into the tension disks.
Threading the Tension Discs
The tension disks are what determine the amount of thread pulled through your machine. Insert your thread into the left tension disk, pulling it gently upwards until it reaches the take-up lever. Be careful not to pull too hard, as this can cause the thread to break or tangle in the bobbin case.
Next, pull the thread downwards and insert it into the right tension disk. Guide it into the take-up lever, ensuring the thread doesn't slip back into the tension disks.
Threading the Needle
With the tension disks threaded, it's time to take care of the needle. Lower the presser foot to keep the fabric in place, then raise the needle bar using the hand wheel. This will expose the needle clamp, allowing you to remove the needle.
Insert your chosen needle into the needle clamp, making sure it's facing the correct direction. You should see a small arrow or 'THIS SIDE UP' marking on the needle – ensure this is facing upwards. Tighten the screw to secure the needle in place.
Threading the Needle and Bobbin Case
Now that the needle is secure, it's time to thread the needle itself. Hold the thread taut and insert it from the front of the needle, pulling it through to the back. Allow around 6-8 inches (15-20 cm) of thread to hang from the back of the needle.
Next, open the bobbin case by unscrewing the shuttle with your fingers. Insert the bobbin, ensuring the thread unwinds in a clockwise direction when viewed from above. Replace the shuttle and tighten it gently.
You're now ready to start your Viking embroidery journey! Remember to always keep your machine lubricated and threads tensioned to ensure the best results. Happy sewing, and may your Viking designs stitches bring you joy and inspiration!