how to test lawn mower ignition coil with multimeter

How to Test Lawn Mower Ignition Coil with Multimeter

By David Rodriguez
AD

When your lawn mower seems unresponsive, the ignition coil could be the culprit. Testing it with a multimeter can help diagnose the issue efficiently. Here's a step-by-step guide to help you understand how to test lawn mower ignition coil with multimeter.

First, gather your tools: a multimeter, a socket wrench for removing the coil, and safety gloves to protect your hands.

Understanding the Lawn Mower Ignition Coil

The ignition coil is a crucial component that converts the battery's 12-volt power into a high-voltage spark to ignite the fuel in your lawn mower's engine.

AD
How To Test And Troubleshoot Ignition Coils - Hunker
How To Test And Troubleshoot Ignition Coils - Hunker
How to Test A Lawn Mower - Ignition Coil Magneto With A Multimeter #easy
How to Test A Lawn Mower - Ignition Coil Magneto With A Multimeter #easy
How to Test a Lawnmower Coil
How to Test a Lawnmower Coil

It's essential to test the ignition coil when you suspect a spark plug issue or other engine problems, as the coil might be at fault.

Locating the Ignition Coil

The ignition coil is typically situated near the spark plug in most lawn mower models. It could be enclosed in a plastic cover or attached to the engine block. Consult your mower's owner's manual if you're having trouble locating it.

How to Test an Ignition Coil
How to Test an Ignition Coil
How To Check A Lawn Mower Coil With An Ohmmeter - Hunker
How To Check A Lawn Mower Coil With An Ohmmeter - Hunker

Once found, ensure the lawn mower is cool and turned off before proceeding with any tests. Wearing gloves is also recommended for safety.

Removing the Ignition Coil

First, disconnect the spark plug wire from the spark plug to prevent accidental starting. Then, using a socket wrench, loosen and remove the coil mounting nut.

AD

Gently pull out the coil from its socket, taking note of its orientation. If it's stuck, you might need to use a rubber mallet to gently tap it out.

Testing the Ignition Coil with a Multimeter

Testing the ignition coil involves checking its resistance and ensuring it's within the manufacturer's specified range. If the resistance is too low or too high, the coil might need replacing.

Set your multimeter to measure resistance (ohms, Ω) and touch the probes to the coil's terminals. For primary resistance test:

AD

Testing Primary Resistance

Touch the black probe to the coil's negative terminal connected to the spark plug, and the red probe to the positive terminal connected to the ignition circuit.

Record the reading. The resistance should be in the range of 0.5 to 2 ohms. If it's significantly higher or lower, the coil is faulty.

Testing Secondary Resistance

Now test the secondary resistance. Touch the red probe to the positive terminal and the black probe to the center terminal (connected to the spark plug).

AD

The resistance should be in the range of 6,000 to 15,000 ohms. If it's outside this range, the coil is likely faulty and needs replacement.

If the ignition coil passes both tests, the issue might lie elsewhere in your lawn mower's ignition system. If it fails, replace the coil with a new one and retest your lawn mower's engine. Regular maintenance can help prevent such issues in the future.

AD