how to test a coil on a kohler engine

How to Test a Coil on a Kohler Engine

By Anthony Robinson
AD

Engine troubleshooting often involves checking components like the coil, which can cause issues if faulty. Kohler engines use coils to ignite the spark in spark-ignition engines. Here's how to test a coil on your Kohler engine.

Before you start, ensure you have a multimeter, a known good electrical connection, and basic safety knowledge. Working on engines involves electrical components, so it's important to know what you're doing.

Understanding the Coil

The first step in testing is understanding what you're dealing with. The coil in a spark-ignition engine takes electrical energy and turns it into a high-voltage spark.

AD
How To Test And Troubleshoot Ignition Coils - Hunker
How To Test And Troubleshoot Ignition Coils - Hunker
How to Test an Ignition Coil with a Multimeter (7-Step Guide)
How to Test an Ignition Coil with a Multimeter (7-Step Guide)
Kohler Engine Troubleshooting Guide: Easy Fixes
Kohler Engine Troubleshooting Guide: Easy Fixes

It consists of a primary and secondary winding. The primary winding is what you connect to, and it's where the low-voltage electrical energy comes in. The secondary winding is much lighter and turns the low energy into high energy, producing the spark.

Inspecting the Coil Visually

Before you break out the multimeter, do a visual inspection. Look for cracks, breaks, or holes in the coil's casing. If it's visibly damaged, replace it, even if it still works. Visual damage means it's going to fail soon.

How to Test a Lawnmower Coil
How to Test a Lawnmower Coil
Ignition Coil Testing with ohm meter for small engines - Briggs-Tecumseh - How To ~ UPDATED
Ignition Coil Testing with ohm meter for small engines - Briggs-Tecumseh - How To ~ UPDATED

Check the connectors as well. Corrosion can prevent the coil from working correctly or not at all. Clean the connectors with a wire brush and use electrical contact cleaner to ensure a good connection.

Testing the Coil with a Multimeter

Only proceed with this step if the coil isn't visibly damaged. You'll need an ohmmeter (multimeter set to resistance) to measure the coil's resistance. First, disconnect the spark plug wires from the coil.

AD

Touch one probe to the high-voltage terminal (center) and the other to the low-voltage terminal. Most coils have around 3-5 ohms of resistance. If it's much higher or lower, or if it's open or shorted, replace the coil.

Checking for Spark

Sometimes, a coil can have the correct resistance but not produce a spark. This could be due to a bad coil, but it could also be a problem elsewhere in the electrical system.

To check for spark, reconnect the spark plug wires. Ground the coil to the engine block using a spark plug wire. Start the engine and listen for a distinct sizzle. If you don't hear anything, there's no spark, and you need to check the entire electrical system.

AD

Resistance and Spark Don't Match Up?

If the coil has the correct resistance but still doesn't produce a spark, it's possible that it's not receiving power. Check the electrical connection from the ignition system to the coil.

Use your multimeter to check voltage at the coil when the engine is cranking. If there's no power, the problem isn't the coil; it's the wiring or the ignition system.

If you've gone through all these steps and confirmed that the coil is bad, replace it with a new one._engineergadget.com/2017/06/kohler-engine-troubleshooting.html

AD

Remember, engine troubleshooting isn't always straightforward. If you're not sure about any part of the process, it's safe to consult a professional. In any case, always prioritize safety when working on engines.

AD