How to Disassemble Shark Navigator Lift-Away
The Shark Navigator Lift-Away is a versatile and powerful upright vacuum cleaner known for its maneuverability and performance. If you find yourself in need of maintenance or replacement of parts, this guide will walk you through the process of taking your Shark Navigator Lift-Away apart in a safe and organized manner. Remember, always unplug the vacuum before starting any disassembly process to ensure safety.
Before you begin, gather a few tools to assist you, such as a screwdriver (for the belt), a small flathead screwdriver (for prying off parts), and a can of compressed air (for cleaning dust and debris). This guide will help you through the process, but if at any point you feel unsure, don't hesitate to contact Shark's customer support for assistance.
Preparing the Vacuum for Disassembly
The first step is to prepare the vacuum cleaner for disassembly. Start by removing the dust cup and emptying it. This will prevent any dust or debris from being released into the air while you're working and make the process cleaner and safer.
Next, ensure the vacuum is unplugged and lay it on its side or back, depending on which parts you're planning to access. For this guide, we'll assume you're working on the upright portion of the vacuum, where the motor and brushroll are located.
Removing the Dust Cup
The dust cup is easily removable. Press the release button on the top of the dust cup and pull it upwards to release it from the vacuum. Empty the dust cup over a trash can and give it a quick rinse with warm water and mild detergent if necessary, then let it air dry before reattaching it.
Reattaching the dust cup is as simple as lining up the arrows and pressing down firmly until you hear it click into place.
Removing the Brushroll
The brushroll on the Shark Navigator Lift-Away can be removed for cleaning or replacement. First, use a small flathead screwdriver to pry off the bottom plate, which covers the brushroll. There are two small tabs that need to be depressed in order to remove the plate.
Once the plate is removed, you should see the brushroll. You may need to use the screwdriver to carefully release the tension on the belt before the brushroll can be removed. Pull the brushroll out and set it aside for cleaning or replacement. Remember to note which end is front and back before removing it to ensure proper reinstallation.
Accessing the Motor and Internal Components
Now that the brushroll and dust cup are removed, you can proceed to access the motor and internal components of the vacuum. Be cautious when handling these parts as they are delicate and can be dangerous if mishandled.
Start by removing the foam filter from its housing. This can usually be done by lifting it out, being careful not to damage the filter in the process. If the filter is particularly dirty, you may need to clean it first before continuing.
Removing the Motor Housing Cover
The motor housing cover can be removed by turning it counterclockwise. Most Shark Navigator Lift-Aways have a latch that needs to be freed before the cover can be turned. Once the cover is off, you'll have access to the motor and other internal components.
Carefully set the cover aside in a safe place where you can keep track of it during the reassembly process. Make sure not to lose any small screws or parts as they are crucial for putting the vacuum back together.
Removing the Motor Belt
The motor belt connects the motor to the brushroll. To remove it, first, locate the belt tension adjuster. This is usually a small screw that can be turned to loosen or tighten the belt. Turn the screw counterclockwise until the belt is loose enough to be removed.
Once the belt is loose, you can pull it off the motor pulley and the brushroll pulley. If you're replacing the belt, make sure to note which way it is supposed to go before removing it. When reinstalling, ensure it goes on in the correct direction and tension is properly adjusted.
Congratulations, you've successfully disassembled your Shark Navigator Lift-Away vacuum! Remember, if you're planning to reassemble the vacuum, ensure all parts are clean and dry before putting them back together. This guide has covered the basics of taking apart the vacuum for maintenance, but if you need to replace parts, always consult the user manual or contact Shark's customer support for further assistance.