how to take apart a vizio remote

"How to Disassemble Your Vizio Remote in Simple Steps"

By Sarah Young
AD

Taking apart a Vizio remote might seem daunting at first, but it's often the best way to diagnose and fix common issues. This guide will walk you through the process, step by step, ensuring you complete the task safely and effectively.

Before you begin, gather a small Phillips-head screwdriver and a container to keep the screws organized. Turn off and unplug your TV to prevent any short circuits. Always remember, disassembling your remote voids the warranty, so attempt this at your own risk.

The Initial Teardown

Begin by inspecting the remote. Look for a small hole under the batteries, often covered by a rubber plug. This is the reset hole. If pressing the reset button doesn't work, we'll need to dive deeper.

AD
How To Fix the Vizio VUR10 Remote
How To Fix the Vizio VUR10 Remote
Vizo Remote Button Functions Explained - Beginners Guide
Vizo Remote Button Functions Explained - Beginners Guide
How to Turn On Vizio TV Without Remote
How to Turn On Vizio TV Without Remote

Using your screwdriver, gently lift the battery door. Underneath, you should see several Phillips-head screws. Remove these carefully, keeping them in a safe place. After the screws are out, gently pry open the remote's casing with a flat tool or your fingers. Be patient; the plastic may be tight.

The Right Half

Once opened, you'll see various internal components. Start by removing the right half of the remote's shell. Look for small tabs or clips holding it in place. Gently wiggle and pull to release it. You might need to use a small flathead screwdriver for leverage.

How to Program a Vizio Smart TV Remote
How to Program a Vizio Smart TV Remote
How to Fix Any Remote at Home
How to Fix Any Remote at Home

Set this half aside, keeping track of its orientation. You'll need to reattach it the same way. Inside, you might find the infrared (IR) LED and its lens, smallcircuit boards, and possibly a spring for the power button.

The Left Half and Circuit Boards

Next, remove the left half of the remote's shell following the same process. Then, carefully lift the top circuit board. You might find it connected to the buttons with thin, flexible membranes. Gently pull to detach these.

AD

Beneath the top board, you'll find another motherboard. Be careful not to damage the contacts or small components as you remove it.

Inspecting and Cleaning Key Components

With the remote fully disassembled, inspect the components for any visible damage. Pay special attention to the diferenctial photo diode (IR receiver) and the IR LED, which may require cleaning with a soft, dry cloth or compressed air.

Check the buttons and switch contacts, ensuring they're clean and funcionaruy. A replacement may be necessary if not.

AD

Cleaning the Contacts

Using a cotton swab dipped in isopropyl alcohol (90% or higher), gently wipe the switch contacts. Be careful not to let liquid drip onto other components. After cleaning, let the remote air dry fully before reassembly.

If the reset didn't fix your issue initially, this cleaning process should do the trick. Reassemble the remote in reverse order, ensuring all components are secured properly.

Reassembly

Replace each component in the reverse order you removed them. Make sure to line up the IR LED and its lens correctly. Carefully click the casings back together, ensuring all tabs and clips are secure. Replace the screws and the battery door.

AD

Test your remote before presenting a victory dance. If all buttons work, congratulations! If not, repeat the process, ensuring each component is cleaned and properly aligned.

Now that you've experienced the art of remote surgery, your Vizio remote should be as good as new. Happy binge-watching!

AD