How to Start Stihl Chainsaw MS170
Starting a Stihl MS170 chainsaw for the first time? You're in the right place. This compact, yet powerful tool is perfect for homeowners and landowners. Today, we'll guide you through the initial startup process safely and effectively. Let's dive in, shall we?
Before you begin, ensure your work area is clean and clear of debris. Always wear appropriate safety gear, including gloves, safety glasses, and hearing protection. Now, let's get your MS170 running!
Preparing Your Stihl MS170
Before starting your chainsaw, there are some crucial safety checks to perform:
First, inspect the chain and guide bar. Ensure the chain is correctly tensioned (not too loose or too tight) and the guide bar is secure. Next, check the chain brake and make sure it's functioning correctly. Lastly, inspect the chain for any dull or loose parts, and replace them if necessary.
Fuel and Lubrication
Fill the Stihl MS170 with fresh gasoline (without ethanol) and 2-cycle oil, mixed at a 50:1 ratio. Make sure to consult your owner's manual for the exact fuel capacity. Then, add a few drops of bar and chain oil into the corresponding hole on the left-hand side of the crankcase.
Top up with the appropriate amount of oil, ensuring the oil level is within the 'FULL' mark on the dipstick. Remember, it's crucial never to run out of oil, as it helps lubricate the chain, preventing excessive wear.
Setting the Choke
The choke controls the air-fuel mixture that goes into the engine. For a cold start, set the choke lever on the left of the engine to 'FULL CHOKE'. This enriches the fuel mixture, making it easier to start. For a warm start, use the 'FRESH AIR' setting.
Throughout operation, you may need to adjust the choke for optimal performance. If your saw is running rough, try enriching the mixture with the choke. If it's running too fast, lean it out with fresh air.
Starting Your Stihl MS170
Now that your chainsaw is primed, it's time to start it. Ensure you're pointing the saw away from your body and any bystanders. Here's how to do it:
First, engage the chain brake by pulling the hand guard forward to prevent the chain from rotating. Next, press the decompression valve (Venturi) on the rear handle, located just above the ignition switch. This makes starting your saw easier by releasing some of the pressure in the cylinder.
Cold Start
For a cold start, follow these steps:
- Move the ignition switch to the 'ON' position.
- Pull the ignition cable sharply and smoothly until you feel some resistance. Release it gently.
- Continue pulling the ignition cable in quick, smooth bursts until the engine starts. Be careful not to flood it with too much fuel.
Warm Start
For a warm start, simply follow these steps:
- Move the ignition switch to the 'ON' position.
- Pull the ignition cable sharply and smoothly until the engine starts.
Once the engine starts, allow it to warm up for a few minutes before using it. After the initial startup, shift the ignition switch to the 'RUN' position and engage the chain with the clutch trigger on the handle.
Congratulations! You've successfully started your Stihl MS170. Always remember to keep your chainsaw well-maintained, store it properly, and inspect it regularly. Happy sawing!