Start Your Stihl 170: A Step-by-Step Guide
Starting up a STIHL 170 chainsaw is a straightforward process, ensuring you follow safety protocols and understand the basics of your tool. This guide walks you through the initial startup procedures, helping you become familiar with your new chainsaw and promoting a safe, efficient work environment.
Before we dive into the startup process, it's crucial to ensure your STIHL 170 is in prime condition. Perform a quick safety check, including tightening all screws, checking chain tension, and ensuring the blade is clean and sharp. Additionally, always wear appropriate safety gear, such as gloves, chaps, and eye protection.
Preparation and Initial Setup
Proper preparation helps ensure a smooth and safe startup experience.
A poorly prepared chainsaw can lead to excessive wear, poor performance, or even injury. Begin by fueling your STIHL 170 with fresh, stabilized gas mixed with the recommended two-stroke oil. For best results, use a fuel can with a constricted spout to prevent overfilling and spills.
Chokepoint and Chain Tension
Adjusting the chokepoint and chain tension is vital for optimal engine performance and cutting efficiency.
To set the chokepoint, turn the choke enricher lever on the carburetor to the " choke" position. After starting the engine, gradually return the lever to the "run" position as the engine warms up. For chain tension, STIHL recommends a specified gap of 0.05 to 0.07 inches (1.25 mm to 1.75 mm) between the chain and the bar, measured at the bottom. Tighten or loosen the chain tensioner screw accordingly.
Cleaning and Lubrication
Keeping your STIHL 170 clean and properly lubricated extends its lifespan and maintains peak performance.
Remove any debris or sawdust from the air filter and spark plug before starting. Once running, periodically apply bar and chain oil to the chain oil hole located at the right-hand side of the engine. This ensures proper lubrication, preventing excessive chain wear and reducing friction.
Starting Your STIHL 170 Chainsaw
With your STIHL 170 prepared and safety measures in place, you're ready to start your chainsaw.
Begin by checking that the chain brake is engaged and the choke is on. Next, place the saw on a stable surface, such as the ground or a stable working platform, and grasp the rear hand guard. Pull the starter rope sharply and firmly in short, smooth motions until the engine starts.
Warm-up and Choke Control
Allow the engine to warm up briefly, then slowly return the choke lever to the "run" position as the needle stabilizes.
If the engine does not start immediately, ensure you're using fresh fuel and that the spark plug is in good condition. Recheck your tension settings, air filter, and carburetor adjustments if necessary. Always refer to your STIHL 170's user manual for specific maintenance and troubleshooting guidance.
Operating Techniques
Now that your chainsaw is running, practice safe operating techniques to preserve your tool and prevent injury.
Always ensure that the chain moves in the correct direction and maintain a secure grip with both hands. Keep your chain off the ground during operation, simulating cutting motions without making contact. Gradually introduce your saw to the wood, keeping the chainSpeed within its recommended range and maintaining control at all times.
After each use, clean your STIHL 170, checking and replacing the oil and air filter as necessary. Store your chainsaw with the chain dressed over a hook or arm to avoid it sagging, contributing to chain alignment issues over time. Understanding your STIHL 170's basics empowers you to utilize its power safely and effectively. Happy cutting!