how to reset etekcity scale

Reset Etekcity Scale: Step-by-Step Guide

By David Young
AD

Is your Etekcity scale acting up, showing incorrect readings or refusing to power on? It might be time to perform a reset. Resetting your scale can often rectify these issues and get it working as good as new. Here, we'll guide you through a simple and safe process of resetting your Etekcity scale.

Before you proceed, ensure that your scale is turned off. Let's dive right in.

Understanding the Etekcity Scale Reset Process

The process involves removing the batteries temporarily to clear any stored data and then replacing them. This is similar to a soft reset on many electronic devices.

AD
an image of a kitchen scale with food on it and instructions for how to use it
an image of a kitchen scale with food on it and instructions for how to use it
Etekcity Digital Kitchen Scale for Weight Loss & Keto | Precision Meal Prep Essential
Etekcity Digital Kitchen Scale for Weight Loss & Keto | Precision Meal Prep Essential
DIGITAL SCALE
DIGITAL SCALE

It's important to note that respondió to resetting your scale will not erase any of your saved data, such as your personal weight or other configurations.

Gathering the Required Tools

Before you commence, make sure you have the following tools and materials on hand:

  1. A crosshead (Philips) screwdriver - usually a size PH1 or PH2 will do.
  2. Your Etekcity scale (of course!)
  3. Replacement batteries that match your scale's specifications.

Locating the Battery Compartment

The battery compartment on your Etekcity scale is usually located underneath, along the bottom edge. It's a small door secured with a screw.

Check your specific model's user manual for the exact location if you're unsure. It's always best to be certain before starting any disassembly process.

AD

Performing the Reset

Now that you're all set, follow these steps to reset your Etekcity scale.

Removing the Battery Cover

Using your crosshead screwdriver, gently remove the screw securing the battery compartment door. The screw should come out smoothly; if it's too tight, you may need to apply a little more pressure.

With the screw removed, lift the battery cover to reveal the battery compartment. Inside, you should see the batteries secured in place.

AD

Removing the Batteries

Carefully pull out the batteries from their slots. If your scale uses multiple batteries, be sure to remember their arrangement so you can replace them correctly.

Once you've removed the batteries, leave them out for about 30 seconds to 1 minute. This gives the scale's electronic memory a chance to clear.

Replacing the Batteries

After the short break, reinsert the batteries back into their respective slots. Ensure they're the correct way around - the positive and negative terminals should match the polarity symbols (+/-) on the battery compartment.

AD

If you're unsure, look at the batteries' packaging for the correct orientation or consult your user manual.

Securing the Battery Cover

Replace the battery cover, ensuring it's properly aligned with the scale's body. Gently reinsert the screw and tighten it back up. Be careful not to overtighten; you could strip the thread or damage the cover.

Testing the Reset

With the batteries replaced and the cover secured, your Etekcity scale should now be reset. Power on the scale and check if the issue has been resolved.

If the reset was successful, your scale should be showing the initial setup menu or displaying the current weight reading. If not, you may need to troubleshoot further or reach out to Etekcity's customer support.

Remember, resetting your scale is like pressing the reset button on your computer or smartphone. It clears any temporary glitches and gives your scale a fresh start. Happy weighing!

AD