how to reset check coolant additive on ford f250

Reset Check Coolant Additive Ford F250: Step-by-Step Guide

By Olivia Allen
AD

Is your Ford F250's check engine light on, indicating a coolant issue? Resetting the coolant additive light on your F250 involves a few steps. Let's delve into the process, ensuring your engine stays cool and performs optimally.

Before we begin, safety first! Make sure your vehicle is turned off and has cooled down to prevent any burns. Once ready, let's guide you through the reset process, keeping your F250's engine in tip-top shape.

Understanding the Coolant Additive Light

Your Ford F250's engine requires a specific type of coolant to maintain optimal operating temperatures and prevent corrosion. The coolant additive light illuminates when it's time to add fresh coolant or coolant additive to maintain the proper chemistry and protection.

AD
HOW TO RESET FORD TPMS LIGHT
HOW TO RESET FORD TPMS LIGHT
NOT Good! $10,138.86 In Damages! Ford F250 F350 F450 6.7l Diesel Fuel System injector Contamination
NOT Good! $10,138.86 In Damages! Ford F250 F350 F450 6.7l Diesel Fuel System injector Contamination
Ford climate control vent defrost issues, F250, F350, Explorer, etc. - Auto Repair Series
Ford climate control vent defrost issues, F250, F350, Explorer, etc. - Auto Repair Series

Resetting the light doesn't replenish the coolant; it merely addresses the warning so you can add the necessary fluid. So, let's begin by resetting the warning light and then address the underlying issue.

Resetting the Coolant Additive Light

Resetting the coolant additive light on your Ford F250 involves a simple process using your vehicle's onboard diagnostic system. Here's how to do it:

How to put Refrigerant in your Car
How to put Refrigerant in your Car
HOW TO REPLACE A/C MODE DOOR ACTUATOR 2009-2014 FORD F150| Get rid of that clicking and ticking!
HOW TO REPLACE A/C MODE DOOR ACTUATOR 2009-2014 FORD F150| Get rid of that clicking and ticking!
  • Turn the ignition to the 'ON' position without starting the engine.
  • Press and hold the trip odometer reset button until the odometer display goes blank.
  • Release the button and wait for the coolant light to turn off. If it doesn't, try turning the ignition off and then back on to complete the process.

Now that the light is reset, it's crucial to address the underlying issue to prevent the light from coming back on too soon.

Adding Coolant or Coolant Additive

Once you've reset the warning light, the next step is to add coolant or coolant additive to your Ford F250's cooling system. Here's how to approach this:

AD

First, locate your vehicle's radiator cap. It's typically in the center of the radiator, near the front of the engine. Allow the engine to cool down completely before removing the cap to prevent injury from hot coolant and steam.

  • Inspect the coolant. If it's dirty, contaminated, or has a strange smell, it's best to drain and refill the system with fresh coolant.
  • Consult your owner's manual for the recommended coolant type for your F250. Most Fo

AD