how to replace the belt on a kenmore dryer

Kenmore Dryer Belt Replacement: Step-by-Step Guide

By Amanda Williams
AD

Got a wobbly or squeaky Kenmore dryer? It might be time to replace the belt. Don't let the task intimidate you; with the right tools and a bit of patience, you can tackle this DIY project. Let's dive into a step-by-step guide on how to replace the belt on your Kenmore dryer.

Before you start, ensure safety first. Unplug the dryer, turn off the gas or electricity, and allow all components to cool down. Gather your tools: a Phillips screwdriver, flathead screwdriver, socket wrench, and a new dryer belt designed for your Kenmore model.

Accessing the Dryer's Interior

To reach the belt, you'll need to disassemble parts of your dryer. Start by removing the back panel to expose the interior.

AD
How to Replace the Belt on a Kenmore 70 Series Dryer
How to Replace the Belt on a Kenmore 70 Series Dryer
How to Replace the Belt on a Kenmore 90 Series Dryer
How to Replace the Belt on a Kenmore 90 Series Dryer
How to Replace the Dryer's Drive Belt? (Step by step instructions)
How to Replace the Dryer's Drive Belt? (Step by step instructions)

For most Kenmore dryers, this involves:

  • Removing the dryer's back panel screws using a Phillips screwdriver.
  • Disconnecting any wires or connections that might be in the way.
  • Slowly sliding the panel off to expose the drum and motor.]()

Locating and Removing the Old Belt

Now that you're inside, locate the old belt. It's typically a triangular or V-shaped rubber belt wrapped around the motor pulley and the drum pulley.

Dryer Belt Replacement – Duet/HE3 Dryer Repair #661570
Dryer Belt Replacement – Duet/HE3 Dryer Repair #661570
How to Replace a Kenmore Gas Dryer Drive Belt
How to Replace a Kenmore Gas Dryer Drive Belt

To remove it:

  1. First, slip the belt off the drum pulley. You can use a flathead screwdriver as a lever to help pry it off.
  2. Next, slide the belt off the motor pulley. You might need to rotate the drum by hand to release the belt.

Installing the New Belt

With the old belt out, it's time to install the new one. Ensure the new belt matches your Kenmore model (consult your owner's manual or measure the old belt if unsure).

AD

To install it:

  1. Position the new belt around the motor pulley and the drum pulley, ensuring it's correctly aligned.
  2. Starting at the motor pulley, wrap the belt around, fitting it onto both pulleys. Tighten it firmly but don't overstretch it.

Reassembling and Testing Your Kenmore Dryer

With the new belt in place, you're almost done. Now it's time to put everything back together.

To reassemble:

AD
  • Replace the back panel, ensuring all screws are secured tightly.
  • Reconnect any wires or components you disconnected earlier.
  • Plug the dryer back in and restore your gas or electricity.

Performing a Test Run

Before you declare the job done, perform a quick test to ensure your Kenmore dryer is functioning properly. Start the dryer and listen for any unusual noises. The dryer should run smoothly and quietly.

If all sounds well, you're done! You've just successfully replaced the belt on your Kenmore dryer. If you notice any issues, double-check all your connections and ensure you've installed the new belt correctly.

Regular maintenance is key to keeping your Kenmore dryer running smoothly and efficiently. By replacing the belt as needed, you'll extend your dryer's lifespan and ensure it performs at its best. Happy DIYing!

AD
AD