how to replace rear strut

Step-by-Step: How to Replace Rear Strut

By Anthony Anderson
AD

Replacing a rear strut is a significant task that requires a measure of automotive knowledge, the right tools, and patience. This guide will walk you through the process, ensuring your vehicle's riding comfort and safety aren't compromised.

Safety is paramount when working on your vehicle. Make sure it's securely supported on jack stands and the emergency brake is engaged. Also, wear appropriate safety gear, including gloves and protective eyewear.

Understanding the Rear Strut

The rear strut, or MacPherson strut, is a critical suspension component. It comprises a spring, a strut tube, and a shock absorber. The strut connects the wheel to the car's body, absorbing road impacts and ensuring a smooth ride.

AD
How to repair a MacPherson strut
How to repair a MacPherson strut
DIY: Rear Strut Replacement
DIY: Rear Strut Replacement
Silverado/Sierra Front Shock Strut Replacement (2014-2018)
Silverado/Sierra Front Shock Strut Replacement (2014-2018)

Since rear struts wear out eventually, knowing how to replace them is a valuable skill. This process can help you save money and understand your vehicle better.

Inspecting the Strut

Before attempting a strut replacement, assess the condition of your vehicle's current struts. Signs of a worn strut include excessive bouncing, abnormal swaying, uneven tire wear, or the vehicle leaning to one side.

How to Replace Struts in your Car or Truck
How to Replace Struts in your Car or Truck
how to install rear strut 1995 corolla. how to remove rear seat 1995 corolla
how to install rear strut 1995 corolla. how to remove rear seat 1995 corolla

To inspect the strut, jack up the vehicle and secure it on jack stands. Visually examine the strut for any leaks or damage. Check the spring and shock absorber for proper functionality by bouncing the tire and observing the strut's response.

Gathering the Necessary Tools

Replacing a rear strut requires a specific set of tools. Gather them beforehand to ensure a smooth process:

AD
  • A floor jack and jack stands
  • Socket wrench with various socket sizes
  • Crowbar or pry bar
  • Penetrating oil and a hammer
  • New strut assembly
  • Torque wrench

Removing the Old Strut

Once you've assessed the strut and gathered the necessary tools, it's time to remove the old strut. This process involves disconnecting several components, so pay close attention to each step.

Start by disconnecting the negative battery cable to prevent short circuits. Then, using your jack and jack stands, lift the vehicle off the ground and support it securely.

Disconnecting the Strut Components

Begin by removing the wheel and tire. Remove all caliper bolts and hang the caliper on a wire or tie it up to keep it from dangling. Next, disconnect the brake hose and electrical connector from the speaker.

AD

Use a crowbar or pry bar to disconnect the lower control arm. You might need to tap it with a hammer after applying penetrating oil. The strut nut should be loose now. Unbolt the strut nut and pull the strut down to remove it.

Installing the New Strut

With the old strut removed, it's time to install the new one. Start by placing the new strut in position and aligning the strut tower. Ensure the spring perch is properly seated.

Tighten the strut nut to the specified torque using your torque wrench. Ensure the new strut is properly aligned with the lower control arm and reconnect it. Reassemble the brake components and the tire.

AD

Finishing Up

Lower the vehicle carefully and reconnect the negative battery cable. Take the vehicle for a test drive at low speeds to ensure the new strut is functioning properly.

Replacing a rear strut can seem overwhelming, but with the right tools and patience, it's a manageable task. Always refer to your vehicle's specific manual for any brand-specific details. Safe driving!

AD