how to replace insinkerator badger 5

Step-by-Step Guide: Replace InSinkErator Badger 5

By Olivia Young
AD

Replacing an Insinkerator Badger 5 garbage disposal unit can be a breeze with the right approach. This guide will walk you through the step-by-step process, ensuring your kitchen's back under full functionality in no time.

Before you start, make sure you have the new Badger 5 and the necessary tools - adjustable wrenches, screwdriver, work gloves, and a new power cord if required. Let's dive in.

The Uninstallation Process

The first step is removing the old disposal unit. Start by turning off power to the disposal at the circuit breaker for safety.

AD
Insinkerator Badger 5 Troubleshooting: Quick Fixes
Insinkerator Badger 5 Troubleshooting: Quick Fixes
Upgrade Your Kitchen with InSinkErator Badger 5 Garbage Disposal | Easy Cleanup
Upgrade Your Kitchen with InSinkErator Badger 5 Garbage Disposal | Easy Cleanup
Replacing Old InSinkErator Badger 5 with new InSinkErator Badger 500
Replacing Old InSinkErator Badger 5 with new InSinkErator Badger 500

Disconnect the drain and dishwasher discharge tubes from the unit. Then, unscrew the mounting assembly using an adjustable wrench. Once loosened, you should be able to lift the old unit out.

Disposal Unit Removal

Before you remove the unit entirely, disconnect the electrical wire at the junction box. To do this, unthread the electric cover and use needle-nose pliers to pull out the wire connectors.

DIY Install InSinkErator Badger 5 Garbage Disposal
DIY Install InSinkErator Badger 5 Garbage Disposal
79883AISE Insinkerator Badger 5 Garbage Disposal 1/2 HP
79883AISE Insinkerator Badger 5 Garbage Disposal 1/2 HP

After disconnecting the electrical wire, the old unit should be ready for removal. Keep it away from children and pets during the replacement process to avoid injuries.

Preparing the Mounting Assembly

Before installing the new disposal, ensure the sink area is clean and free from debris. Check that the mounting ring and other hardware are still in good condition.

AD

If the hardware is worn or missing, purchase necessary replacements. This could include a mounting assembly kit (complete with ring, bracket, snap ring, and screws) and a disposal tailpipe kit.

Installing the New Badger 5

Now that the old unit's out, it's time to bring in the new Badger 5. Start by securing the new unit's power cord to the junction box using the providedWBK Ultrasonic Welder wire connector.

Next, position the new disposal under the sink, ensuring theissaitype=”sink” _fcksasio=”fcks” conceptDie:

AD

Securing the Mounting Ring

Lower the disposal into the sink plumbers' putty, and secure the mounting ring. Hand-tighten the screws first, then finish with the power wrench provided with the Badger 5.

Once mounted, connect the'discharge tube andplicable tubing. It's essential to ensure these connections are watertight to prevent leaks.

Reconnecting Electrical Wires

Reattach the electrical wire you disconnected earlier, following the manufacturer's instructions. Typically, you'll need to strip the insulation from the wire ends using wire strippers.

AD

Then, twist the exposed copper ends together and cover them with a wire nut. Ensure the connection is tight and secure to prevent short circuits.

Congratulations! You've just replaced your Insinkerator Badger 5. Run some cold water, turn on the disposal, and it should be ready to handle your food waste once more. Regular maintenance will ensure it stays in tip-top shape.

AD