Step-by-Step Guide: Replace Heating Element in Amana Dryer
Is your Amana dryer not heating up when it should? The likely culprit might be a faulty heating element. Don't worry, replacing it isn't as complicated as it sounds. With this step-by-step guide, you'll soon have your dryer up and running again.
Before you start, ensure you have the necessary safety gear - gloves, goggles, and a face mask - and place a protective cloth or blanket over the dryer to catch any parts that might fall off during the process. Also, make sure to unplug the dryer from the power source for safety.
Identifying and Removing the Heating Element
First, locate the heating element. It's usually located behind the access panel at the bottom of the dryer. Consult your dryer's manual if you're unsure.
Now, let's remove the access panel. On most Amana dryers, this involves removing the screws at the bottom corners of the panel. slide it off and set it aside.
Disconnecting the Wiring
You'll see the heating element at the back of the dryer. It's a coil of wire that's been bent into a horseshoe shape. Before you touch it, ensure it's completely cool. The element is connected to the dryer's electrical system by terminals or screws at each end.
Using a Philips screwdriver, loosen the screws and pull the wires out of the terminals. If the ends are bent over, straighten them out first. Be careful not to damage the wires or terminals. After disconnecting, tag the wires to ensure they're rewired correctly.
Removing the Old Heating Element
After disconnecting the wires, the heating element should slide right out. If it doesn't, it might be attached to the dryer housing with retaining screws or clips. If so, remove these first.
Pull the element out carefully, and inspect it for any signs of damage, such as blackened areas, which could indicate overheating or short-circuiting. If the element is in good condition, consider cleaning it before installing it back - but remember, this is only if you plan to reuse it, not replace it.
Installing the New Heating Element
Now that the old element is out, it's time to install the new one. Ensure the new element is identical to the old one in length, width, and wire size. If you're unsure, take the old element to the store with you when purchasing a new one.
If the new element doesn't fit perfectly, you may need to adjust the dryer's housing or relocate the appliance itself. Never force the element into place, as this could damage it or the dryer.
Securing the New Heating Element
Slide the new element into place, ensuring it's fully seated and secure. If the element was secured with screws or clips, make sure these are tight but not overtightened. You don't want to strip the threads or damage the element.
Reconnect the wires to the new element, ensuring they're fully seated in the terminals. If the wires were tagged when you removed them, match the tags to the correct terminals. If not, use the old element as a guide. Tighten the screws securely but not overtightened.
Reassembling the Dryer
After the element is secure, reinstall the access panel. Ensure all screws are secure and the panel is flush with the dryer's body.
Plug the dryer back into the power source, and restore it to its original position. Run a test cycle to ensure the dryer is heating correctly. If it is, congratulations! Your Amana dryer is as good as new.
Remember, if at any point you feel unsure about the process, don't hesitate to call a professional. DIY repairs can save you money, but they can also cause more damage if not done correctly. Happy fixing!