Step-by-Step: Replacing Your Harley Davidson's Clutch Lever
If you're riding a Harley-Davidson and noticing your clutch lever feels unusually stiff ortotally unresponsive, it might be time for a replacement. A faulty clutch lever can spoil your cruising experience and, more importantly, impact your bike's safety. So, let's gear up and dive into a step-by-step guide on how to replace your clutch lever on a Harley Davidson.
Before we start, ensure you have the necessary tools: a socket wrench, a ratchet, an Allen wrench, and some Threadlocker. Also, make sure your bike is on a sturdy center stand or a level surface with the kickstand securely engaged. Always remember, safety first when working on your Harley.
Assessing the Damage
It's crucial to understand the extent of the problem before proceeding. Inspect your clutch lever both visually and for any resistance when pulling or pushing it.
If the problem lies solely with the cable, a replacement might suffice. However, if the cable is fine yet the lever doesn't function correctly, replacing the complete clutch control kit might be necessary.
Gathering Your Parts
Assuming you've decided to replace the entire kit, ensure you have the correct part. For Harley Davidson models, you'll typically need a new clutch control kit (includes cable, lever, and handlebar housing), a clutch cable end adjuster (if not included in the kit), and some Threadlocker.
Verify your bike's model and ensure the kit is compatible. You might have different clutch lever parts depending on the year, model, and setup of your Harley.
Preparing Your Harley
Start by removing any protective covers or other components that might obstruct your access to the clutch lever and surrounding area.
Next, locate and remove the clutch cable end adjuster at the back of the handlebar housing. It's usually held in place by a small grub screw. After loosening the screw, use your Allen wrench to unscrew the adjuster completely.
Removing the Old Lever
Begin by detaching the clutch cable from the clutch perch. You'll typically find it secured by a cable tie or a retaining clip. Carefully remove the tie or clip, then separate the cable from the perch.
At this point, the lever's plastic bushing or the entire unit might fall out. If not, gently twist and pull the lever to remove it, taking note of its position and alignment to aid reinstallation.
Cleaning Up
With the old lever gone, it's time for a thorough clean. Use a suitable degreaser to clean the clutch cable route, the handlebar housing, and the clutch perch area.
Inspect the clutch cable for any signs of wear or damage. If it's in good condition, you can continue using it. Otherwise, consider replacing it as well.
Installing the New Lever
Start by applying Threadlocker to the clutch cable end adjuster's thread. This will help maintain the adjuster's position and prevent it from vibrating loose.
Slip the clutch cable through the handlebar housing and engage it with the clutch perch. Ensure you maintain the correct tension on the cable, keeping it firm but not too tight.
Adjusting the Clutch Lever
Incorrect adjustment can lead to clutch slippage or a hard-to-pull lever. Thus, it's crucial to get this right.
To begin, loosen the clutch cable end adjuster all the way. Then, reinstall and tighten your new clutch lever while slowly pulling the cable to apply tension.
Final Touches
Once tightened, double-check the clutch lever's free play. It should have about 0.75 to 1 inch of movement before it starts to engage the clutch. If necessary, make fine adjustments using the clutch cable end adjuster.
Finally, reattach any protective covers, ensuring you replicate the original routing as precisely as possible to prevent any potential interference or damage.
There you have it! Your Harley Davidson now sports a fresh new clutch lever, ready to tackle the open road with renewed precision and reliability. Happy riding and always prioritize safety above all else.