DIY: Replace ADT Motion Sensor Battery (Step-by-Step)
While ADT motion sensors are known for their durability, batteries aren't exactly built to last forever. If you're seeing a "Low Battery" alert on your ADT control panel, it's time to replace the battery in your motion sensor. Here's a step-by-step guide to help you through the process.
Before we get started, ensure you have the following tools and materials at hand: a new 3-volt lithium battery (CR2032 or CR2450), a small flathead screwdriver, and your ADT system's alarm code. Let's dive in!
Preparation and Disarming Your System
First, you'll need to disarm your ADT system to prevent it from sounding an alarm during battery replacement.
1. Head to your control panel and enter your alarm code. This will disarm the system.
Locating the Motion Sensor Battery
Now that your system is disarmed, it's time to locate the battery in your motion sensor.
1. ADT motion sensors are usually installed on walls or ceilings, near entrances or in high-traffic areas. Identify the sensor and carefully remove the casing. The process varies by model, but typically involves unscrewing or snapping off the cover.
Removing the Old Battery
With the casing removed, you should see the battery. It's usually held in place by a small compartment with a locking tab.
1. Use your flathead screwdriver to carefully release the locking tab. This should allow the battery to pop out.
2. Remove the old battery and discard it according to your local recycling guidelines.
Installing the New Battery
Now that the old battery is out, it's time to install the new one.
First, ensure you have the correct battery. ADT motion sensors use either a CR2032 or CR2450, depending on the model. If you're unsure, check your ADT system's documentation or contact their support.
Inserting the New Battery
1. Align the positive side of the new battery (marked with a '-') with the marked fatigued in the battery compartment.
2. Carefully insert the new battery until it locks into place.
Reassembling and Testing Your Motion Sensor
With the new battery installed, it's time to test your motion sensor and put everything back together.
1. Replace the motion sensor casing. Ensure it's securely fastened and the LED indicator is visible.
2. Test the motion sensor by walking by it. The LED should flash briefly if the battery is working correctly.
3. Arm your ADT system using the control panel. Your motion sensor should now function as normal.
Congratulations, you've successfully replaced the battery in your ADT motion sensor! Regular maintenance like this will keep your home security system running smoothly. If you ever encounter any issues, don't hesitate to contact ADT's professional support.