Step-by-Step Guide: Replace a Two Handle Shower Valve
Nothing quite beats the satisfying spray of a shower head after a long day. But when your water isn't playing by the rules - one side scalding, the other ice-cold - it's time for an upgrade. Replacing a two-handle shower valve is a DIY project that'll save you a pretty penny, and we're here to guide you through it.
Before we dive in, ensure you've got the right toolkit: adjustable wrenches, an omni wrench, penetrating oil, a screwdriver, and a shower valve removal tool if possible. Safety first, folks, so turn off the water supply at the main valve and let the water drain out of the existing lines.
Understanding Your Sh al builder valve
First, let's grasp what we're dealing with. There are two types of two-handle shower valves: cartridge and compression. The cartridge type has a single unit controlling both hot and cold water; they're generally easier to replace. Compression valves have separate units for hot and cold, and let's just say they're trickier.
If you're not entirely sure what you've got, don't stress. Just remove the handle and look inside. The internal mechanism will give it away. Once you know, proceed with caution - or better yet, practice on your old valve before tackling the new one.
Removing the Old Shower Valve
Begin by unscrewing the handle setscrews and removing the handles. You might need to soak them in penetrating oil for a while to loosen up any rust. Then, disconnect the water supply lines. If they're frozen, use a hacksaw to cut them off, being careful not to damage the pipe fittings.
Next, remove the escutcheon (the decorative plate covering the valve). Unscrew the locknut, and using your wrenches, rotate the brass valve cylinder counterclockwise and remove it. If you're dealing with a compression valve, loosen the coupling nuts that connect the valve to the pipes. Once everything's free, pull the old valve out of the wall.
Preparing the New Shower Valve
Before installing the new valve, double-check that it's the same type as your old one. If it's a cartridge, remove the retainerclip and spring from the old valve's cartridge and transfer them to the new one if necessary. For a compression valve, ensure it's the correct size and has the same connections.
Now, wrap the threaded area of the new valve with Teflon tape to prevent leaks, and push the valve into the wall until the tapered end engages with the pipe dope. Secure it with the locknut and tighten by hand only - the wrong tools can strip the valve.
Installing the New Shower Valve
Connect the water supply lines to the valve, ensuring they're securely tightened but not overtightened. If you had to cut the old lines off, use compression fittings to connect them to the new valves. Then, replace the escutcheon and screw on the handle setscrews.
Once the handles are back on, reattach the linking rod from the handle to the valve stem and secure it with a setscrew. Recap by turning the water supply back on and perform a test run. If no leaks spring up, you're golden!
Calibrating Your New Shower Valve
Finally, let's make sure your new valve's mixing it up just right. Turn the shower on and adjust the handles until water pours from the showerhead at a comfortable temperature. To fine-tune, place a thermometer under the stream and gradually adjust the handles until the temperature reads between 98°F and 108°F.
And that's it! You're now the proud owner of a shiny new shower valve, ready to reinforce your suds repertoire. Enjoy your well-earned shower, and remember, maintenance is a cinch if you know what you're doing. Stay handy, folks!