how to replace a starter on a honda accord

Step-by-Step: Replace a Starter on a Honda Accord

By Ashley Williams
AD

Is your Honda Accord refusing to turn over, leaving you stranded? The culprit might be a faulty starter. Replacing it isn't as daunting as it sounds. With a bit of know-how and the right tools, you can do it yourself and save on mechanic fees. Let's guide you through the process.

First, gather your tools. You'll need a socket set, breaker bar, 1/2-inch drive socket, needle-nose pliers, autopsy knife, and a new starter motor compatible with your Accord's year and model.

Removing the Old Starter

Before you start, ensure your vehicle is safely supported on jack stands and the engine is cool to prevent any burns.

AD
How Much Does It Cost To Replace A Starter In A Honda Accord?
How Much Does It Cost To Replace A Starter In A Honda Accord?
Easy Way to Replace the Starter in a Honda Accord
Easy Way to Replace the Starter in a Honda Accord
How to Replace a Low Beam Headlight Bulb on a Honda Accord (2002-2007 North American Models)
How to Replace a Low Beam Headlight Bulb on a Honda Accord (2002-2007 North American Models)

Begin by disconnecting the negative battery cable to prevent short circuits. Then, locate the starter motor, usually at the lower front of the engine, connected to the bell housing.

Disconnecting Wires and Solenoid

Using needle-nose pliers, carefully pull the large starter solenoid cable off the starter motor. Then, remove the smaller wire connected to the starter motor's terminal.

Honda Accord Sport 2015: Starter Replacement Guide
Honda Accord Sport 2015: Starter Replacement Guide
Alternator Replacement Picture Guide – Honda Accord
Alternator Replacement Picture Guide – Honda Accord

Use the autopsy knife to detach the ignition wires tied with a cable tie. Pull them away from the starter motor to give you enough room to work.

Removing the Fasteners

With the starter motor now exposed, use the 1/2-inch drive socket and breaker bar to loosen and remove the starter motor's mounting bolts. There are typically three or four bolts holding the starter in place.

AD

Once all bolts are loose, carefully lower the starter motor down from the engine. The Flexplate (part of the engine's flywheel) may rotate slightly, so be careful of your hands and tools.

Installing the New Starter

Before installing the new starter, compare the old and new starters to ensure they're identical. If they differ, double-check you've got the correct part for your Accord.

Position the new starter motor into place, aligning the mounting holes with those on the bell housing. Ensure the starter solenoid lines up with the engine block mounting point.

AD

Mounting the New Starter

Insert the mounting bolts through the bell housing and starter motor, then securely tighten them using the 1/2-inch drive socket and breaker bar. Tighten the bolts to the manufacturer's specified torque.

Reconnect the large starter solenoid cable and the smaller wire to their respective terminals on the starter motor. Ensure they're fully seated and secure.

Reconnecting the Wires and Battery

Reinstall the ignition wires, securing them with the cable tie. Reconnect the negative battery cable, ensuring it's clean and free of corrosion.

AD

Test your work by trying to start your Accord. If the engine turns over smoothly, you've successfully replaced your starter motor. If not, double-check all your connections and ensure the new starter was installed correctly.

Regular maintenance is key to keeping your Honda Accord running smoothly. If you're unsure about any part of the process or don't feel comfortable performing the repair yourself, consult a professional mechanic. Happy wrenching!

AD