how to replace a breaker switch

Step-by-Step Guide: Replace a Breaker Switch Safely

By Brian Miller
AD

Safety first: Always turn off the main power at the electrical service panel before replacing a breaker switch.

The process might seem daunting, but with the right tools and steps, replacing a breaker switch can be a manageable DIY project. Here's a comprehensive guide to walk you through the process.

Preparation and Safety Measures

Before you start, ensure you have the right tools and safety precautions in place.

AD
How To Replace Or Move A Circuit Breaker
How To Replace Or Move A Circuit Breaker
How to Add a Breaker Switch (with Pictures)
How to Add a Breaker Switch (with Pictures)
How to Reset a Circuit Breaker
How to Reset a Circuit Breaker

**Tools Needed:** Voltage tester, screwdriver (flat and Phillips), needle-nose pliers, new breaker switch, and suitable replacement breaker (same amperage and voltage rating).

Turn Off Power

Locate your electrical panel, usually in a utility room, basement, or outside your home. Inside, turn off the main breaker to cut power to the entire house.

How To Reset a Tripped Circuit Breaker Due To Electrical Overcurrents
How To Reset a Tripped Circuit Breaker Due To Electrical Overcurrents
Circuit Breaker Won’t Reset? | Try These Fixes
Circuit Breaker Won’t Reset? | Try These Fixes

Once powered off, use a voltage tester to confirm there's no power going to the wires. This essential safety step ensures you won't be electrocuted while working.

Identify the Faulty Breaker

Your breaker panel should be labeled, making it easy to identify the faulty breaker. If it's not labeled, you'll need to match the wires in the panel to the rooms they serve, which might require turning the power back on briefly for testing.

AD

**Tips:** Some breaker panels have a diagram on the door. If your panel doesn't, you can create one or use a smart breaker panel app for better tracking.

Replacing the Breaker Switch

Now that you've identified the faulty breaker, it's time to replace it.

**Safety Note:** If the breaker is hot (turns back on when you try to remove it), or the wires are damaged, call a professional electrician immediately.

AD

Remove the Old Breaker

Open your electrical panel and locate the faulty breaker. Use a flathead screwdriver to trip the breaker to the 'off' position, then remove the screw holding the breaker in place.

Gently pull the breaker out of the panel, using needle-nose pliers if needed. Set it aside carefully, keeping track of how it was installed (which way was the handle facing?).

Install the New Breaker

Take your new breaker and insert it into the panel, aligning it with the rails and ensuring the proper side faces out. The label should be visible, and the handle should be in the 'off' position.

AD

Secure the breaker using the screw you removed earlier, ensuring it's tight but not overtightened. Flip the handle to the 'on' position to test the breakers. If all goes well, you've successfully replaced the breaker switch.

Final Testing and Safety Checks

Before you close up the panel, perform a quick visual check to ensure all breakers are properly installed and secured. Also, double-check that the main breaker is still in the 'off' position.

Slowly turn the main breaker back 'on' and test the replaced circuit to ensure power has been restored. If the breaker trips immediately, there might be an issue with your new breaker or wiring.

Regularly inspect your breakers and electrical panel for any signs of wear or damage. Safety first should always be your top priority when dealing with electrical work. If you're unsure about any step, don't hesitate to call a professional electrician.

AD