how to remove screen from larson storm door

Step-by-Step Guide: How to Remove Screen from Larson Storm Door

By Emily Smith
AD

Is your Larson storm door screen bent, torn, or worn out? Replacing it isn't as daunting as it may seem. Let's guide you through the process of how to remove the screen from your Larson storm door. With the right tools and steps, you'll have your Larson storm door looking good as new in no time.

Before we dive into the removal process, ensure you have the necessary tools at hand. You'll need a flathead screwdriver, needlenose pliers, a pair of work gloves, and a new storm door screen. Now let's get started.

Preparing Your Larson Storm Door

Before you begin, make sure the door is fully closed and locked. This will ensure the screen is taut and secure, making the removal process smoother.

AD
How to Change a Screen Door to a Glass Storm Door
How to Change a Screen Door to a Glass Storm Door
How to Repair Your Screen Door
How to Repair Your Screen Door
Replacement flat spline for Emco full view storm/screen door
Replacement flat spline for Emco full view storm/screen door

Next, put on your work gloves to protect your hands from any sharp edges or punctures. Now, let's move on to the removal process.

Removing the Handle and Lock Assembly

The first step is to remove the handle and lock assembly. Start by using your needlenose pliers to carefully squeeze and release the tabs on both sides of the latch mechanism. Once the tabs are released, you should be able to slide the latch mechanism out.

How to Clean and Maintain Your Larson Storm Door | Larson Doors
How to Clean and Maintain Your Larson Storm Door | Larson Doors
Easy Fix for a Screen/Storm Door Closer
Easy Fix for a Screen/Storm Door Closer

Now, using your flathead screwdriver, unscrew the large screws holding the handle in place. Once the screws are removed, you should be able to lift the handle out. Be cautious not to damage the door's finish during this process.

Removing the Screen Panel

After removing the handle, locate the small screws along the perimeter of the screen panel. Using your flathead screwdriver, remove these screws. There might be quite a few, so take your time and make sure you get them all.

AD

Once all the screws are removed, carefully lift the screen panel out. It should pop right out if you've removed all the screws. If it's resistant, double-check that you've removed all the screws and that there are no remaining tabs or fasteners.

Installing the New Screen Panel

With the old screen panel removed, it's time to install the new one. Line up the new screen panel with the door frame, ensuring it fits properly.

Once you've ensured it's aligned, start screwing the new panel in place. Begin with the top and bottom screws, then move to the sides. Tighten the screws firmly, but be careful not to overtighten and strip the screws or damage the door frame.

AD

Reattaching the Handle and Lock Assembly

Now that the new screen panel is secure, it's time to reattach the handle and lock assembly. Begin by placing the latch mechanism back into the door, then push the tabs back into place to secure it.

Next, align the handle and secure it using the large screws you removed earlier. Use your screwdriver to tighten these screws firmly, but again, be careful not to overtighten.

Congratulations! You've successfully learned how to remove the screen from your Larson storm door and installed a new one. Regular maintenance like this will keep your door looking and functioning its best. Happy DIYing!

AD
AD