Easy Steps to Remove & Replace Outboard Steering Cable
When the steering of your outboard motor becomes stiff or sluggish, it might be due to a flaw in the steering cable system. Removing and repairing or replacing this cable can restore smooth steering and ensure safe navigation. Let's guide you through the process of how to remove an outboard steering cable, step by step.
Before you start, rounded up some essential tools: a socket wrench, flathead screwdwriver, needle-nose pliers, a utility knife, and possibly a ratchet and socket set. You'll also need replacement parts like a new cable, its housing, and lubricant. Safety first: always disconnect the battery and make sure the engine is cool before working on it.
Disconnecting the Cable
Start by loosening the tension on the cable to ease removal. Look for the adjustment nut on theFlexible cable attached to the engine. Loosen it using the socket wrench, but don't completely remove it yet.
Next, head to the control arm at the helm. This is where the cable connects to your steering wheel or tiller. Using the flathead screwdriver, loosen the set screw that holds the clevis pin in place. This pin secures the cable end.
Removing the Cable From the Engine
Back at the engine, locate the drain plug on the lower unit. Remove it to drain any old lubricant from the cable housing. This will make pulling out the cable easier and less messy.
Now, remove the clamp that holds the cable housing to the engine. Use the needle-nose pliers to carefully pry it off. Once loose, use the utility knife to cut the tie-wrap or string holding the cable in place. Gently pull the cable out from the bottom.
Removing the Cable From the Helm
Return to the helm. With the set screw removed, use the needle-nose pliers to pull out the clevis pin. This will release the cable from the steering mechanism. Pull the cable carefully out through the starboard side of the boat.
If the cable is frozen in place, you may need to use some penetrating oil to help lubricate and loosen it. Spray it into the cable end and let it sit for a while before trying again. Sometimes, you might need to replace the cable housing as well, to ensure smooth operation in the future.
Inspecting and Replacing the Cable
Once removed, inspect the old cable for any signs of wear or damage. If it's frayed, kinked, or rusty, it's best to replace it. Also, check the cable housing for any cracks or leaks, as these can lead to further damage.
If everything looks fine, you can clean the old cable and housing, lubricate them, and reuse them. Otherwise, purchase a new cable kit that includes a cable, housing, and lubricant. It's crucial to use marine-grade cable and lubricant to ensure they withstand the harsh boating environment.
Reinstalling the Cable
Start by threading the new cable (or the cleaned one) through the engine's steering arm and into the lower unit. Make sure the eyelet at the end of the cable is oriented correctly.
Push the cable all the way through until the eyelet reaches the small hole in the engine’s steering arm. Then, insert the new clevis pin through the hole and the cable's eyelet. Secure it with a new set screw.
Securing the Cable
At the helm, secure the cable back to the control arm. Position the cable so that it's straight and has no twists or kinks. Tighten the set screw to secure the cable in place.
Back at the engine, lubricate the new cable (or the cleaned one) thoroughly. Then, insert the clamp back into place, securing the cable housing to the engine. Tighten it gently with the needle-nose pliers.
Finally, check that the steering mechanism feels smooth and responsive. Tighten the adjustment nut on the engine side until the steering is correct. Don't over-tighten, as this can damage the cable and steering system. Remember to reconnect your battery and you're ready to go.