Remove Moen Toilet Paper Holder
If you're here, it's likely because you've been grappling with a stubborn Moen toilet paper holder that's seen better days. Don't worry, you're not alone. Moen is known for its durability, but even the toughest units can wear out over time, or maybe you're just ready for a change? Whatever the reason, let's dive into how to remove that Moen toilet paper holder in a few simple, step-by-step processes.
First, let's cover the basics. Moen toilet paper holders come in two main types: wall-mounted and floor-mounted. Both can be removed, but the process differs slightly. Regardless of the type, the first step is to gather your tools. You'll need a screwdriver (Philips or flathead, depending on your holder model), a wrench, and optionally, some pliers and a bucket to catch any water.
Removing a Wall-Mount Moen Toilet Paper Holder
Wall-mount holders are typically secured to the wall with screws. Here's how to remove them:
Safety first: Turn off the water supply to your toilet at the valve behind the toilet or below the tank. Flush the toilet to empty the tank, then use a towel or rag to absorb any remaining water in the bowl to avoid spills.
Unscrew the Holder
Using your screwdriver, remove the screws that secure the holder to the wall. If the screws are stuck, you can use a bit of WD-40 to loosen them up before trying again.
After unscrewing, carefully pull the holder from the wall. There may be some resistance, so be patient and gentle to avoid damaging the wall or the holder. At this point, you can rinse the holder and set it aside for reinstallation or disposal.
Clean Up
With the holder removed, you'll likely see some old hardware and possibly dried-up putty or caulk. Use a putty knife or razor blade to scrape off any excess, then wipe the area clean. If desired, you can sand the wall lightly to make any needed touch-ups less obvious.
Removing a Floor-Mount Moen Toilet Paper Holder
Floor-mount holders are connected to the plumbing, so removing them requires a bit more care. Here's how to proceed:
Preparation: Again, turn off the water supply before proceeding. This time, you'll also want to prepare a bucket to catch any residual water. Place it under the supply line to protect your floor from any leaks.
Remove the Supply Line
Using a wrench, carefully loosen the compression nut that holds the supply line to the holder. Counterclockwise motion is the key here. Once loosened, use your hands to unscrew the supply line from the holder. Be careful; you might be dealing with some water, especially if the nut was stuck.
If the supply line doesn't budge, you might need to use a pipe wrench. If that's the case, wrap the pipe with a cloth or use a pipe wrench cover to protect it from damage. Once you've removed the supply line, wipe off any excess water with a towel.
Unscrew the Holder
With the supply line removed, you should now be able to unscrew the holder just like in the wall-mount scenario. Use your screwdriver, and if necessary, a bit of WD-40 to loosen any stubborn screws.
After unscrewing, carefully pull the holder from the floor. If it's stuck, gently rock it back and forth until it comes loose. Remove the hardware, including any mounting bolts or anchor screws, for recycling or reuse.
And there you have it! You've successfully removed your erstwhile Moen toilet paper holder. Now, whether you're replacing it with a new one or updating your bathroom decor, you're well on your way to a fresh new look.
Just remember to turn your water supply back on once you're done. And who knows? Maybe the next challenge will be installing that new holder - but that's a tutorial for another day. Happy upgrading!