how to remove liftmaster wall control

How to Remove LiftMaster Wall Control

By Nicole Martin
AD

Tired of your LiftMaster wall control causing inconvenience with its faulty performance? Fear not, getting it removed is easier than you think. Our comprehensive guide will walk you through the process, ensuring your safety and successful removal of the wall control unit.

Before you begin, ensure you have the necessary tools: a flathead screwdriver, needle-nose pliers, and a ladder or step stool for safety when working at heights. Also, turn off your garage door opener's power at the main electrical panel to avoid any electrical hazards.

Preparation and Safety Measures

Safety should always be your priority. Apart from powering off the garage door opener, also disconnect any wires connected to the LiftMaster wall control.

AD
How to Program LiftMaster's 971LM and 973LM Remote Controls to a Garage Door Opener
How to Program LiftMaster's 971LM and 973LM Remote Controls to a Garage Door Opener
How to Remove a Non-Loadbearing Wall to Bring More Light Into Your Space
How to Remove a Non-Loadbearing Wall to Bring More Light Into Your Space
How To Remove A Load-Bearing Wall
How To Remove A Load-Bearing Wall

Locate your garage door's philosophy. If it reads, "Energy Savings or Life Safety: If the door does not close or open, wave a broom in front of the photo eye to reset," you have a crucial safety feature at play. Test the photo eye using a broom to confirm it works properly before proceeding.

Step 1: Disassembly of the Control Panel

Begin by removing the wall control panel from its mounting bracket. Use your flathead screwdriver to gently pry the control panel off. In most cases, there's a small indentation where you can insert the screwdriver tip. Gently apply pressure and the panel should pop off.

How to Remove Texture From Walls
How to Remove Texture From Walls
The Best Way to Remove Plaster from a Wall or Ceiling
The Best Way to Remove Plaster from a Wall or Ceiling

Once disassembled, you'll notice two wires connected to the back of the panel. These wires might be held down by a metal staple or tucked behind a plastic clip. Use your needle-nose pliers to carefully remove the staple or the clip, freeing the wires.

Step 2: Removing the Mounting Bracket

The mounting bracket might be secured using screws. Remove these screws using your flathead screwdriver. If the bracket is secured with plastic snaps, you can gently twist and wiggle it until it pops off.

AD

After removing the bracket, assess the space left on the wall. If you want to patch up the hole, you'll need to sand the wall surface, apply spackling compound, then paint or wallpaper to match the surrounding area.

Alternative: Removing Wall Control When Wiring is Encased

Some LiftMaster wall controls may have their wiring encased within a junction box. If that's the case for you, follow these steps:

Using your screwdriver, carefully remove the screws around the junction box rim. Pull the box out of the wall, revealing the wiring. Be cautious as pulling too hard might damage the wires.

AD

Step 1: Disconnect the Wires

You'll see two wires connected to terminals within the junction box. Use your flathead screwdriver or needle-nose pliers to gently twist and pull these wires off the terminals. Be patient and careful not to damage any wires.

Once disconnected, carefully tuck the wires back into the wall. If the junction box is faulty or unsafe, consider replacing it before installing new wiring.

Step 2: Removing the Wiring and Closing the Hole

If the wiring is long enough, you might be able to pull it back into the hole in the wall. If not, you'll need to patch the hole by using the same steps mentioned earlier: sanding, applying spackling compound, then painting or wallpapering to match the surrounding area.

AD

Congratulations! You've successfully removed the LiftMaster wall control from your garage door. If you're planning to replace it with a new one, make sure to follow proper installation guidelines for the best results.

AD