how to change battery in liftmaster wall control

Change Liftmaster Wall Control Battery: A Step-by-Step Guide

By Richard Moore
AD

Is your LiftMaster garage door opener wall control running low on battery? Replace it with these step-by-step instructions. Let's ensure your garage door operates smoothly and safely at all times. Here's how to change the battery in your LiftMaster wall control.

First, let's gather the required tools. You'll need a flathead screwdriver, a new 12-volt battery (exact type can be found in your user manual or by checking the existing battery), and a couple of minutes of your time. Safety glasses are also recommended when handling tools and batteries.

Preparation and Accessing the Battery Compartment

Before you begin, ensure the garage door is in the down position and the opener is turned off. This prevents any accidental operation while you're working.

AD
How to Change the Battery in Your LiftMaster Remote Control
How to Change the Battery in Your LiftMaster Remote Control
A-1 DSC How to Change out Your System Battery
A-1 DSC How to Change out Your System Battery
Troubleshooting A LiftMaster With A Flashing Light - Hunker
Troubleshooting A LiftMaster With A Flashing Light - Hunker

Next, locate the small hole near the bottom of your wall control. This is where you'll insert your flathead screwdriver to access the battery compartment.

Removing the Cover

Using your flathead screwdriver, carefully insert it into the hole and push the tab to release the cover. The cover should now pop open, revealing the battery compartment.

How To Jumpstart A Cordless Drill Battery
How To Jumpstart A Cordless Drill Battery
🆕Chamberlain/LiftMaster MyQ Garage Door Remote Programming
🆕Chamberlain/LiftMaster MyQ Garage Door Remote Programming

If you're having trouble, try using a coin or a different tool to fit the hole better. Remember to be gentle to avoid damaging the wall control.

Removing the Old Battery

Upon opening the cover, you'll see the old battery. It's usually a 12-volt battery with a positive (+) and negative (-) terminal. The positive terminal is usually marked with a '+' sign or indicated by the red wire connected to it.

AD

Gently lift the old battery out of the compartment, ensuring you don't touch the terminals to prevent short circuits. You may need to disconnect the battery wires if they're preventing it from coming out.

Inserting the New Battery

Once the old battery is out, take your new battery and align it with the compartment. Ensure the positive (+) terminal on the battery matches the positive (+) terminal in the compartment.

If the battery isn't fitting, double-check the polarity. Inserting a battery with reversed polarity can damage your wall control.

AD

Positioning the New Battery

Slowly insert the new battery into the compartment. The battery should fit snugly, and the connector clips should snap into place. If they don't, gently press down on the battery until you hear them click.

If you're having trouble, ensure the battery is fully inserted and the connectors are properly aligned. Never force the battery in, as this could damage the connectors.

Reattaching the Cover

With the new battery securely in place, carefully align the cover and slide it back onto the wall control. You should hear a satisfying click when it's properly secured.

AD

If the cover isn't closing, double-check that the battery is fully inserted and not interfering with the cover. You may also need to jiggle the cover a bit to find the correct alignment.

Congratulations! You've successfully changed the battery in your LiftMaster wall control. Test the wall control by operating your garage door to ensure everything is working properly. If you encounter any issues, double-check your battery connection and ensure it's in the correct position. Always remember to dispose of old batteries responsibly to protect our environment.

AD