how to remove kohler shower handle with set screw

How to Remove Kohler Shower Handle with Set Screw

By Emily Martin
AD

whether it's due to wear and tear, a design change, or just a desire for an updated look, removing a shower handle with a set screw can seem like a daunting task. However, with the right steps and a bit of confidence, you can replace that old Kohler shower handle in no time. Let's dive into a comprehensive guide on how to remove a Kohler shower handle with a set screw.

Before we begin, gather your tools: a flathead screwdriver, an adjustable wrench, a Phillips head screwdriver, pliers, and possibly a precision screwdriver. Also, don't forget to have your new handle and any necessary replacement parts on hand to ensure a seamless transition.

Preparation and Turning Off the Water Supply

Start your project by turning off the water supply to your shower. Typically, this involves using the shut-off valve near your shower or under your home. Make sure to open the shower faucet to relieve any remaining water pressure.

AD
How to Remove Shower Handle Sans Screws: DIY Guide
How to Remove Shower Handle Sans Screws: DIY Guide
Trying to remove a single handle shower faucet with stripped out set screw
Trying to remove a single handle shower faucet with stripped out set screw
How to Remove Your Delta Shower Handle: A Complete Guide
How to Remove Your Delta Shower Handle: A Complete Guide

Next, remove the escutcheon, the plate that covers the hole in the wall where the shower arm sticks out. This can usually be done by prying it off with a flathead screwdriver or by unscrewing it if it's securely attached.

Removing the Set Screw and Cotter Pin

To access the set screw, you'll need to remove the shower arm escutcheon. Once you've done that, you'll see the set screw, which is usually located near the base of the shower handle. Use your flathead screwdriver to loosen and remove the set screw. It may be quite tight, so you might need to use an adjustable wrench or pliers for some extra torque.

How to remove and tighten a screwless Kohler shower handle
How to remove and tighten a screwless Kohler shower handle
How to Replace Two-Handle Shower Valve? | Replace Two-Handle With Showers
How to Replace Two-Handle Shower Valve? | Replace Two-Handle With Showers

After the set screw is removed, you should be able to pull the shower arm out of the wall. You might need to twist it slightly to get it to come out. Once it's out, you'll find a small piece of metal called a cotter pin sticking out of the end of the shower arm. This pin keeps the shower handle in place. To remove it, use pliers to gently pull it out. It might be stuck, so again, a bit of extra force using pliers might be necessary.

Dismantling the Shower Handle

With the cotter pin removed, unscrew the screws holding the shower handle together. A Phillips head screwdriver should do the trick. You may need to use a bit of force, as the screws can be stubborn. With the screws removed, the handle should come apart, revealing the innards.

AD

Now, carefully remove the old handle. Depending on the model, you might need to use pliers or a precision screwdriver. If you're replacing the entire fixture, package up the old parts for recycling or disposal. If you're just replacing the handle, set the old one aside for the moment.

Inspecting the Old Parts

Before you start installing the new handle, take a moment to inspect the old parts. Check the shower arm and the area inside the wall where it sticks out for any signs of damage, rust, or corrosion. If you find anything, you might need to replace the entire fixture rather than just the handle. In most cases, though, all you'll need to do is clean up the area a bit to ensure a smooth install of your new handle.

Once you've inspected the old parts and cleaned up the area, it's time to start installing your new Kohler shower handle.

AD
AD