how to rebuild dewalt 18v batteries

How To Recharge Dewalt 18V Battery

By Emily Allen
AD

The robustness of your Dewalt tools is only as good as the power behind them. A faulty 18V battery can dampen your productivity and put a halt to your projects. Here's a step-by-step guide to help you rebuild your Dewalt 18V battery, restoring it to its former glory and saving you from buying a new one.

Before you dive in, be aware that this process requires some basic soldering and electrical knowledge. Safety first - wear appropriate protective gear and ensure your workspace is well-ventilated.

Preparation: Gather Your Tools and Materials

To successfully rebuild your Dewalt 18V battery, you'll need the following tools and materials:

AD
HOW TO REBUILD 18V DEWALT NICD/NIMH BATTERY
HOW TO REBUILD 18V DEWALT NICD/NIMH BATTERY
Rebuild an 18v Drill Pack for 15 Bucks!
Rebuild an 18v Drill Pack for 15 Bucks!
How Do I Recycle Dewalt 18V Batteries? - Sciencing
How Do I Recycle Dewalt 18V Batteries? - Sciencing
  • A multi-meter
  • A soldering iron
  • Lead-free solder
  • Diagonal cutters
  • Needle-nose pliers
  • Wires (without a battery, it's hard to specify, but you'll know what you need)

Inspect Your Battery

Use the multi-meter to test each cell in your battery pack. Dewalt 18V batteries typically have three cells. If any cell is reading below 8V, it's time for replacement.

Before you start, let your battery rest for a couple of hours. This ensures accurate readings and helps prevent any short circuits during the rebuild process.

two black batteries sitting on top of a wooden table
two black batteries sitting on top of a wooden table
DeWalt 20V Max 3AH Battery Repair
DeWalt 20V Max 3AH Battery Repair

Discharge and Disassemble Your Battery

Using the multi-meter, verify that your battery has been fully discharged. This ensures safety while you work on it.

Carefully disassemble your battery pack. This usually involves prying off the plastic casing, revealing the circuit board and individual cells. Be gentle to avoid damaging any internal components.

AD

Replace the Faulty Cells

Once you've identified the faulty cells, it's time to replace them. You can source new cells from a variety of hardware stores or online retailers.

Strip and Solder the New Cells

Use your diagonal cutters to strip the insulation off the wires connecting to your new cells. Ensure you're leaving enough wire length for reassembly.

Tin the exposed copper on both your new cell wires and the intact wires on the circuit board. Then, carefully solder the new cells in place. Ensure all connections are clean and robust.

AD

Reassemble Your Battery

Once you've soldered in the new cells, carefully reassemble your battery. Ensure all connections are secure and the circuit board is properly connected to the case.

Test your battery using your multi-meter to verify all cells are reading around 7.4V. If your readings are still low, double-check your connections and ensure all cells are fully charged.

Test Your Rebuilt Battery

Before you power up your tools, perform a final test on your battery. Charge it up to 100% and let it sit for a couple of hours before discharging it completely. This helps to condition the battery and ensure its performance.

AD

Safety First: Check for Leaks

After the safety test, check for any signs of leaks. Battery acid can damage your tools and your workspace. If you spot any leaks, reseal your batterypack or replace it entirely.

Your rebuilt Dewalt 18V battery should now be ready to power your projects. With a little patience and some DIY know-how, you've restored functionality to your tools and saved some money in the process.

Happy building! Regularly maintain your battery to optimize its lifespan and keep your Dewalt tools operating at their peak performance.

AD