how to reassemble faucet aerator

How to Reassemble Your Faucet Aerator in Easy Steps

By Laura Lopez
AD

Ever noticed a decline in water pressure or a strange hissing noise from your faucet? It might be due to a clogged or damaged faucet aerator. Thankfully, you can easily remedy this by reassembling your faucet aerator at home. Let's dive into this simple yet essential DIY procedure.

Before we start, remember that this process varies slightly depending on the type of faucet you have - compression, ball, or cartridge. Here, we'll discuss a general step-by-step guide that applies to most faucet types. You'll need a few basic tools: an adjustable wrench, pliers, a flathead screwdriver, and possibly a smaller Allen wrench for cartridge faucets.

Preparation and Disassembly

르크Before you begin, ensure you turn off the water supply to the faucet. Look under your sink for a shutoff valve and turn it clockwise until it stops. If there's no shutoff valve, you'll need to turn off the main water supply to your house.

AD
Replace Your Faucet Aerator - WaterSense Bath Hack #2
Replace Your Faucet Aerator - WaterSense Bath Hack #2
Fixing a Faucet Aerator: You CAN be a DIY
Fixing a Faucet Aerator: You CAN be a DIY
How to Remove Recessed Faucet Aerator
How to Remove Recessed Faucet Aerator

Next, place a bucket underneath the faucet to catch any residual water. Now, start dismantling the aerator. Firstly, unscrew the aerator from the end of the faucet using the adjustable wrench or pliers. Be careful not to damage the finish. If it's too tight, wrap the jaws of the wrench or pliers with tape for better grip.

Removing the Screen

Once you've removed the aerator, you'll see the screen. This is where the blockage usually occurs. Take it out and clean it to remove any buildup. If it's severely damaged or clogged, it might be best to replace it with a new one.

How To Remove A Faucet Aerator That Is Stuck
How To Remove A Faucet Aerator That Is Stuck
Remove Water Faucet Hidden Aerator (Delta)
Remove Water Faucet Hidden Aerator (Delta)

To remove the screen, you might need to unscrew it using the flathead screwdriver or an Allen wrench, depending on your faucet type. Some screens simply pop out with a bit of twisting and pulling.

Cleaning the Aerator Assembly

After removing the screen, clean the entire aerator assembly to ensure no debris or minerals are left behind. You can soak it in vinegar for 15-20 minutes to help dissolve any mineral build-up. Then, scrub it gently with a soft brush to remove any remaining residue.

AD

While cleaning, be careful not to bend or warp the internal parts of the aerator. If your aerator has a filter, ensure you clean it or replace it according to the manufacturer's guidelines.

Reassembly and Testing

Now that everything is clean, it's time to reassemble your faucet aerator. Start by reattaching the screen. If you need to screw it back in, make sure it's secure but not overtightened.

Next, place the aerator back onto the faucet. Hand tighten it initially, then use the wrench to secure it. Be careful not to overtighten and strip the finish or the aerator itself.

AD

Replacing the O-Ring

If your faucet aerator uses an O-ring, ensure you replace it before reassembly. Over time, O-rings can harden and crack, leading to leaks. A new O-ring will ensure a snug fit and prevent drips.

Before installing the new O-ring, smear a small amount of food-grade oil or candle wax around its edges. This will help lubricate it and make it easier to install the aerator. Once you've replaced the O-ring, proceed with reassembling the aerator as mentioned earlier.

Test the Reassembled Faucet Aerator

Finally, turn the water supply back on and test your faucet. The water pressure should be improved, and the hissing noise should be gone. If not, double-check that everything is securely fastened and the screen is properly aligned.

AD

If you've followed these steps carefully, you should now have a fully functional faucet aerator. Regularly cleaning and maintaining your aerator can help extend its lifespan and prevent future clogs or damage. Happy DIY-ing!

AD