How to Reattach Track on Bobcat
Tracking on Bobcat loaders is essential to prevent replacement tracks and damage to the undercarriage. Replacing tracks due to improper tensioning can be expensive, time-consuming and detrimental to your operation. Here's how to correctly replace a track on your Bobcat, ensuring longevity and optimal performance.
Before starting, ensure you have the necessary tools: a track tension gauge, 3/8" drive socket, 3/8" drive ratchet, pry bar, impact wrench (optional but helpful), and a few jack stands. Also, wear safety glasses and gloves to protect yourself from debris and potential hazards.
Safety and Preparation
Always place your Bobcat on a level surface to maintain the correct track tension. If the ground is uneven, use jack stands to level the machine. Consult your operator's manual for specific guidance on your model.
Before working on your Bobcat, engage the parking brake and block the wheels to prevent unexpected movement. Shut off the engine and allow the machine to cool down to prevent burns. Disconnect the battery cables to ensure there's no electrical power flowing through the machine.
Removing the Damaged Track
Use a pry bar to carefully lift the damaged track's inside lip and slide it off the sprocket. This requires some force but should not cause any damage. Once you've freed the track from the sprocket, it will slide off the grousers easily.
If your Bobcat is equipped with a hydraulic-powered tensioning system (like the Bobcat T770 and T870), you'll need to release the track tension before sliding the track off the sprocket. Use the tension gauge to ensure the track's tension is released completely, then disengage the sprocket and slide the track off.
Measuring Track Tension
Track tension is critical for optimal performance and machine life. Over-tightening can cause accelerated wear, while under-tightening can lead to excessive slipping. Use a track tension gauge to ensure your track is within the recommended range - usually between 400-700 pounds of tension.
Measure tension at the top of the track, midway between the front and rear idlers. The gauge should be positioned perpendicular to the track, with the dial facing you. Pull the gauge until it reaches its second click, then read the tension in pounds. If the tension is outside the recommended range, you'll need to adjust it.
Replacing the Track
Start by sliding the new track's inside lip onto the sprocket teeth. You may need to use the pry bar to seat the lip properly. Once the lip is on the sprocket, slowly walk the track onto the idlers and around the machine, ensuring it seats correctly on all the grousers.
Once the track is fully seated, begin tightening it to the correct tension. If your Bobcat has a hydraulic-powered tensioning system, pump the hydraulic track tightener until the tension gauge reads within the recommended range. For manual tensioning systems, use a 3/8" drive socket and ratchet to tighten the adjustment bolts until the tension gauge reads correctly.
After adjusting the tension, run the machine in forward and reverse gears to seat the track properly. Recheck the track tension one last time, then reinstall any removed covers and replace the machine's battery cables. You're now ready to get back to work!