How to Fix Drawstring Shorts: Simple Step-by-Step Guide
Losing or removing the drawstring from your favorite pair of shorts can be quite frustrating, leaving you with gaping waistline and droopy fit. Fortunately, with the right tips, you can easily put the drawstring back in and restore your shorts to their original shape. This guide will walk you through step-by-step process, incorporating helpful tips to ensure the drawstring stays put for longer.
Before we dive in, let's identify the right tools you'll need: your drawstring (hopefully still in hand), a safety pin, a small wooden or plastic spoon, and a needle (for an extra secure hold). With these at your fingertips, you're ready to get started.
Preparing for Insertion
The first step in putting the drawstring back in your shorts is to locate the casing. The casing is the channel inside your shorts where the drawstring usually resides. It runs through the waistband and is often hidden within the seam.
Before you start, it's important to check if your drawstring is long enough. A good rule of thumb is to have about 12 inches on either side for tying. If it's too short, you may need to look for a longer replacement to ensure a secure fit.
Locating the Casing
To find the casing, start by feeling along the waistband of your shorts. You'll notice a small opening, usually located at a seam or hem. If the drawstring was recently removed, it may be easy to spot. If not, use a safety pin to trace along the seam until you find the opening.
Once you've found the opening, use a safety pin or a small hook to gently pull out a few inches of casing to form a makeshift ' jugó' to feed the drawstring through. This will make threading the drawstring much easier.
Threading the Drawstring
Start by inserting the end of the drawstring into the casing using the safety pin or a small wooden/ plastic spoon. Gently push and wiggle the spoon or pin until the drawstring is about an inch or two inside the casing.
Now, turn your shorts inside out. This will give you better access to the other side of the casing. Use the safety pin (or spoon) again to pull the drawstring through to the other side. Keep a steady tension on the drawstring as you pull it through to avoid bunching or kinking.
Securing the Drawstring
With the drawstring now threaded through the casing, it's time to secure it in place. The goal is to ensure the drawstring won't easily slip out and that it's pulled taut for a snug fit.
Start by tying a knot on the inside of the shorts, where the drawstring initially passed through the casing. This will prevent the drawstring from slipping back into the casing and will provide a starting point for your bow.
Tying a Secure Knot
To tie a secure knot, start by looping the drawstring around itself to form a half-knot. Pull both ends of the drawstring to tighten. Then, loop the drawstring around itself again in the opposite direction, creating a full knot. Pull tight to secure.
To further secure the knot, you can use a needle to create a 'securing stitch.' Insert the needle through the drawstring and fabric where it intersects, creating multiple small 'x' stitches to hold the drawstring in place. This stitch can help prevent the knot from loosening over time.
Tying the Drawstring Bow
Once the drawstring is knotted and secured, you can tie it into a bow. Here, you'll want to create balance and symmetry in your bow to ensure your shorts fit well and look great.
Start by creating a basic 'over-under' bow, pulling each end of the drawstring through the loop on the opposite side. Then, gently pull on both ends of the bow to tighten and adjust until it looks even and balanced. Make sure the bow isn't too tight or too loose, as this can affect the fit and comfort of your shorts.
And there you have it! With these steps, you've successfully put the drawstring back in your shorts. The next time you wear them, be sure to give it a test tug to ensure the drawstring is secure and stay tight.