How to Prime a Pressure Washer Pump: Step-by-Step Guide
Pressure washers are powerful tools for cleaning tough surfaces, but their effectiveness largely depends on the condition of their pump. A well-primed pressure washer pump ensures smooth operation and longevity. Let's delve into the process of how to prime a pressure washer pump efficiently.
Before we start, it's crucial to ensure safety. Always turn off the power supply and allow the pump to cool down if it's just been used. Wearing gloves and safety glasses is also recommended to protect your hands and eyes from any debris or chemicals.
Understanding Your Pressure Washer Pump
To prime your pressure washer pump effectively, it's essential to understand its components. The two main types of pressure washer pumps are wobble plate and axial cam pumps. Both have an inlet valve and an outlet valve. The inlet valve sucks in water, and the outlet valve expels it at high pressure.
In some cases, you might have an unloader valve, which helps with the priming process by diverting water away from the pump when the trigger isn't pulled. Familiarize yourself with these components to better understand the priming process.
Preparation: Drain and Disconnect
The first step is to drain any residual water from the system. This is to prevent any water from being pumped back into the water source, which could potentially cause damage or contamination. You can do this by disconnecting the inlet and outlet connections from the pump.
Next, pull the pump trigger to expel any remaining water. This step is crucial as it helps to remove any air within the system and primes the pump for the next use.
Prime the Inlet Valve
The inlet valve pulls water from the source. To prime it, fully open the inlet valve. If your pressure washer has an unloader valve, partially close it to increase the suction power. Then, turn on the power. The pump should start drawing water, and after a few moments, you'll see water flowing at the outlet.
Once the pump is drawing water consistently, turn off the power and allow the water to flow for a few more seconds to ensure the entire system is water-filled. Then, close the inlet valve and reopen the unloader valve if you had previously closed it.
Priming Your Pressure Washer Pump in Short Hoses or Without Gravity Feed
If you're using a short hose, you might struggle to prime your pressure washer due to insufficient water pressure. In such cases, you can use a separate pump, a water-filled bladder tank, or even a siphon.
To use a siphon, simply submerge the tube inside the water source and place the other end into the pump's inlet. The siphon effect will draw water into the pump, filling the system and priming it.
Using a Water-Filled Bladder Tank
Filling a bladder tank with water and placing it higher than the pump can also create sufficient water pressure to prime your pressure washer. The water will flow into the pump, filling it and expelling any air.
Remember to displace the air in the bladder tank by compressing it before placing it above the pump. This ensures that water, not air, is pushed into the pump. After the process, you can simply release the compression and use the bladder tank as a normal water container.
Maintaining Prime During Use
Even after priming your pressure washer pump, it can lose its prime over time. Air can seep in through the inlet valve, causing your pressure washer to lose pressure. To maintain your pump's prime, keep the inlet valve partially open when not in use.
Moreover, if your pressure washer has an unloader valve, ensure it's not leaking by periodically checking for water flow when the trigger isn't pulled. A leaking unloader valve can cause your pressure washer to lose prime.
Regular maintenance of your pressure washer's pump is crucial to keep it performing at its best. Priming your pump is an essential part of this maintenance, ensuring smooth operation, enhancing longevity, and maximizing your cleaning experience.