Easy Schlage Door Handle Installation: Step-by-Step Guide
SCHLAGEs are renowned for their durability and sleek design, known for adding a touch of class to any door. Installing a Schlage door handle is a straightforward DIY task, and we're here to guide you through the process. Let's dive into the step-by-step process, ensuring your new handle is securely attached in no time.
Before we begin, ensure you have the following tools ready: a screwdriver (Phillips or flathead, depending on your handle set), a drill, and a tape measure. You'll also need the Schlage handle set you've purchased, which includes the lever, deadbolt, and strike plate.

Preparation and Measure
Start by removing the existing handle. Unscrew the screw connecting the knob to the handle, and pull the door handle off. Next, measure the center of your door from edge to edge. This measurement will help you determine the correct size for your Schlage lever and deadbolt.
The Schlage handle set should come with matching knobs and deadbolts. If your door is standard (1 3/8" or 35mm), your new Schagle handle should fit perfectly. If your door is thicker or thinner, you may need to adjust your handle set accordingly.
Installing the Deadbolt
Shut the door and mark the location where you want to install the deadbolt.
Using a drill bit slightly smaller than the deadbolt's shaft, drill a hole to the depth specified in the instructions provided with your Schlage handle set.
Align the Faceplate
Hold the faceplate against the door, lining it up with the hole you've drilled. The faceplate should cover the hole. Using a pencil, trace the outline of the faceplate. This will help you know where to align the template provided with your handle set.
Place the template on the door, aligning it with the pencil marks. Using a drill bit that matches the size of the screw holes, drill through the door at the spots marked on the template.
Insert the Deadbolt
Insert the deadbolt through the latch side of the door, aligning it with the hole you drilled earlier. Make sure the tailpiece of the deadbolt is facing the opposite side of the door.
Place the faceplate on the door, ensuring it covers the tailpiece and hole. Using the screws provided, secure the faceplate and deadbolt to the door.
Installing the Lever
Close the door and hold the Schlage lever against the hole where you want to install it. Mark the screw holes on the door using a pencil.
Drill the Holes
Drill holes at the marked spots using a drill bit that matches the size of the screw holes. Don't drill too far or you might damage the door.
Attach the Latch
Insert the latch through the hole from the non-handling side of the door. Ensure the lever is correctly aligned and the latch plate is flush with the door.
Using the screws provided, secure the lever and latch plate to the door. Tighten the screws, but be careful not to overtighten and strip the screws.
Give your Schlage handle a few tries, ensuring it operates smoothly and the deadbolt locks and unlocks without issue. If everything functions as it should, congratulate yourself on a job well done!
Remember, always follow the specific instructions provided with your Schlage handle set, as some models may have slight variations in the installation process. Now, enjoy the new and improved look – and functionality – of your door!