how to fix overfilled oil

Fix Overfilled Engine Oil: DIY Steps & Tips

By Thomas Smith
AD

Overfilling your engine oil can cause serious problems, from reduced engine performance to costly repairs. If you've topped up your oil too much, don't worry – it's fixable. Let's dive into how to fix overfilled oil, step by step.

Before we begin, it's crucial to understand that oil expands when heated. So, if your engine is hot, the oil level might appear higher than it actually is. Always check the oil level when the engine is cool for the most accurate reading.

Understanding the Problem

Overfilled oil can lead to excess pressure in your engine, potentially causing oil leaks and damage to engine components. It can also lead to reduced fuel efficiency and increased emissions. The first step is to diagnose the issue accurately.

AD
oil being poured into an engine with the words, too much engine oil? easy diy fix
oil being poured into an engine with the words, too much engine oil? easy diy fix
Fixing Too Much Oil in Your Lawn Mower - symptoms of overfilled oil in your lawn mower
Fixing Too Much Oil in Your Lawn Mower - symptoms of overfilled oil in your lawn mower
how to get oil filter off with screwdriver
how to get oil filter off with screwdriver

Use your dipstick to check the oil level. If the oil is noticeably above the 'FULL' mark, even after the engine has cooled down, you have overfilled oil.

Draining Excess Oil

Once you've confirmed the issue, it's time to remove the excess oil. This process involves a few simple steps:

Symptoms of Overfilled Engine Oil
Symptoms of Overfilled Engine Oil
What happens if you overfill your engine oil?
What happens if you overfill your engine oil?

Gathering Tools

Before you start, make sure you have the necessary tools. You'll need an oil filter wrench, a 13mm socket wrench (for most cars), an oil catch pan, and some new engine oil.

It's also a good idea to have a funnel, a jacket or apron to protect your clothes, and some rags or paper towels on hand.

AD

Draining the Oil

Find your oil pan at the bottom of your engine. It's usually located near the front of your car. Place your oil catch pan underneath, then using your socket wrench, loosen and remove the oil pan's drain plug. Be careful, as the oil may be hot.

Allow all the oil to drain completely. This might take a few minutes. Once the oil has stopped draining, reinstall and tighten the drain plug. Remember, not too tight – you don't want to strip the threads.

Replacing the Oil Filter

While you're at it, it's a good idea to replace your oil filter. Here's how:

AD

Removing the Old Filter

Position your oil catch pan underneath the oil filter. Using your oil filter wrench, turn the filter counterclockwise to loosen and remove it. If it's too tight, you can tap it with a rubber mallet to loosen it.

The filter may leak a bit of oil once removed, so be careful not to spill it into the engine bay.

Installing the New Filter

Rub a small amount of new engine oil around the gasket of your new filter. This helps create a better seal and makes it easier to remove later. Then, screw on the new filter by hand, turning it clockwise.

AD

Tighten the filter until the gasket just touches the engine block, then back it off about a quarter to a half turn. This ensures a good seal without overtightening.

Refilling the Engine Oil

Now that you've drained the excess oil and replaced the filter, it's time to refill the engine oil to the correct level.

Adding New Oil

Consult your car's owner's manual to determine the type and amount of oil to add. Using your funnel, slowly pour the recommended amount of oil into the engine through the oil fill hole.

After filling, wait a few minutes to allow the oil to settle, then recheck the oil level using your dipstick. The oil level should be between the 'ADD' and 'FULL' marks on the dipstick.

Checking for Leaks

Start your engine and let it run for a few minutes. Then, recheck for any oil leaks around the oil pan and filter. If you find any, tighten the respective bolts a little more, being careful not to overtighten.

Congratulations, you've successfully fixed your overfilled oil issue! Regularly checking your oil level and changing your oil as recommended by your vehicle's manufacturer will help prevent this issue in the future. Always remember, prevention is better than cure.

AD